Testing Hook Clip Probe Test Leads Electronics Silicone Test Leads 50cm/19.7Inch Length - 5pcs

Worked great used with a transformer to activate all lawn sprinkler valves at the same time to winterize lawn sprinkler systems. Now I can winterize in half the time

Used this set to connect a USB to TTL UART board to an ESP-01 with pads instead of a header for its UART connection. Only needed about five minutes of grip to flash the ESP. These held on and didn't slip. No errors in programming. Impressive.

These are really light weight leads. Don't try to use them as hookups for anything that will carry significant current. The clips seem a little flimsy though they work fine as long as you are gentle with them. Their main purpose is for connecting test leads (probably not in high amp mode) or light duty hookup in tight spaces and for that they get the job done. If you're looking to run more than a few hundred milliamps through them, you might want to consider a higher capacity (lower gauge) set.

Have had them just a short time, seem to be good quality.

These are not high quality minigrabbers, which is why they are inexpensive. I would not recommend for daily use. However, they work well enough for small projects, but tend to break if used often.

Such a steal. These long leads have silicone multi-colored insulators that are rated at 3kV and 24 gauge. The wires are so soft and flexible that it's freaky, and so slender that they barely take up any room in my electronics go-bag! I'm really into miniature stuff and these are perfect for my needs. I use a super tiny Amprobe PM51A multimeter and the grabbers on these leads are exactly the right diameter to click into the grooved ends of my multimeter's leads. It's like they're made to grab that little slot on a standard probe tip. I couldn't be happier with these things. Such a bargain! I've bought three packs of them and I cut the middle of the wires out of one set to make super short (about 2.5 inches of wire) leads for joining things that are near to each other. I wish I could find this fantastic wire on a reel! It's completely amazing!

Possibly the most helpful item I have purchased in a long time for testing electronics. Like having an extra set of hands. Probe Clips hold tight on items and make it very easy to test electronic items with my Digital Multimeter and analog Amp/mAmp Meters. I will be ordering more because have found I also use them with breadboard projects to connect items several inches away from the breadboard.

These are great, the silicone helps with longevity and easy of use, although they do have quite a spring to them. The clipping head is great, although large for some tiny connections near SMD.