Antrader 1.5 Inch Diameter PVC Round Table Chair Leg Tips Caps,Black,4-Pack

Perfect fit will help to prevent rust

Worked like a charm. Material seems sturdy. Didn’t disappoint.

Good for table legs that are a bit smaller than 2". The measurement they give is 2" OD, so it's a tight squeeze to fit on legs that are 2" As far as the product, it's very good quality and the felt below is just thick enough.

3/4 ID used to cap the sharp ends of an aluminum tube laundry rack.The original caps were white plastic and cracked over time. The Antrader caps were white, soft flexible rubber that easily went on the aluminum tubes and stayed on. Better than I thought based on the negative comments about them being thin and not flexible. All wrong. I cannot address their longevity on chair legs but for capping the aluminum tubes on a laundry rack, they were perfect, A+.No more cuts and scrapes from the sharp tube ends.

I only needed 2 feet because I was putting them on a kitty bed that goes in a windowsill so Scott wood feet that sit on my wall and I didn’t want the wood feet to move or scratch my wall because I have 2️⃣ kitties jumping up and down into that bed off & on all day long. these rubber feet are perfect . I could pick the size I wanted and I got a one by two or something like that, it wasn’t real big and it fit perfect

these are what I needed, and they're cheap, and they fit well, so I can't complain from that front. That said, the felt it pretty thin and inset in the rubber. about 1 in 4 of these feet have felt thin enough that the rubber rubs on the floor an make the chairs skid noisily on the floor, which is what i was trying to avoid as I have downstairs neighbors that have been complaining about noise from moving chairs/furniture around. If you don't care about noise or how smooth these glide on the floor and just care about protecting your floors, these are great, otherwise I would probably find others with thicker felt.

I've bought the more common sort of felt pads for furniture legs, the sort that you have to stick on, and these are definitely easier to use, and most effective in doing their job which is to keep furniture from scratching wood floors. I used this set of 'feet' for 6 antique dining chairs with round legs which I MEASURED to be sure to order the right diameter caps. They slid on fairly easily and were snug enough so that they won't come off by accident. The felt pads are thick enough to protect the hardwood floors and allow the chairs to slide easily (with or without occupant).

Very good but wrong size.

Works well have rectangle legs on dinner table chairs, approx 20mm x 10mm and they fit well. Had for a 4 months and they’re still going good!

This product was perfect for the application

Something I was looking for a long time to refurbish my old dining chair where it was squeaky all the time due to the worn out caps under it’s legs. There is a solution all the time with Amazon. You need to check properly the sizes and my order was fitting perfect. Thanks to the manufacturer and Amazon for the solution and great product.

Al parecer la medida es mas grande que la descrita, pegamos las fundas a la pata de la silla con silicón pero aún así queda grande y se mueven, pero igual sirven. No es un mal producto, solo que debería ser un poco más apretado

Work well