MokerLink 16 Port PoE Switch with 2 Gigabit Uplink Ethernet Port, 250W High Power, Support IEEE802.3af/at, Rackmount Unmanaged Plug and Play

Needed a PoE switch for some IP Cameras. Works as expected and was relatively cheap.

Simple, Straight forward can’t miss. This power over Ethernet worked perfectly with my ROE security cameras

I have had this switch in use for a couple of months, running a home security camera network. The switch easily provides enough power to run 8-9 PoE cameras, of which one is a PTZ. The performance has been solid with no switch related outages, and it maintains the bandwidth well. Granted, my setup does not max out the stated 100 Mbps bandwidth (I am observing a 60 Mbps constant throughput), but in my application it is 100% solid. I wanted a fanless design to keep my network corner quiet, and this switch is perfect for that. I think that I would buy another one of these if I needed to add more cameras instead of buying a larger port count switch with a fan. Having two non-PoE uplink ports is very helpful, this way I was able to run one uplink to the router to use DHCP for the cameras VLAN, and the other uplink to the dual NIC PC that runs Blue Iris, without having to take up a PoE port for that. This way there is zero camera traffic on the LAN, and the cameras can be easily isolated from calling home or being accessed from the outside. 100 Mbps is totally adequate for camera use for this port count, there is no need for a gigabit switch for this purpose.

I purchased two of these, one on 12/23 and one on 2/24 to use with my Reolink POE camera system. I had a number of older cameras that I was integrating into a newer base unit with some newer upgraded cameras. Reolink will tell you this cannot be done but it can if you set it up correctly. In any case, they worked perfectly until one failed on 11/25. I bought the same one as a replacement. Maybe the longevity isn't what it should be, but I feel they are a pretty good value for the money.

This is a great unit — a 6-port hub with Power over Ethernet (POE) and two uplink ports. I’ve outfitted all my Raspberry Pi 3+ and newer models with POE hats, and this hub powers them flawlessly. Setup was smooth, and performance has been rock-solid. If you're building a Pi fleet or need a compact, reliable POE switch for small deployments, this is the one to get. Clean design, dependable power delivery, and just the right number of ports. Highly recommended.

the unit works well with my camera setup.

These work well if installing IP cameras. It is not a managed switch however that does not matter.

It works well so far with 4 x 15 watt cameras attached. I will probably not get close to the max wattage, since my cameras are 15 watt or below. I don't dig the super bright led used on it, but the built-in power supply is nice to keep things neater. I have not tested the 10 Mbps mode that allows you to increase the length of cable to 250 meters.

This product isn't working, had to but another one.

SUPER POE

No se ha instalado

Macht, was er soll. Einfach zu montieren.

Décu par 2 netgear 16 ports poe+ 180w renvoyés car aucun ne pouvait alimenter mes 12 caméras 4k a 15m. Ce switch Mokerlink fonctionne parfaitement et a plus de puissance 250w. Le comble c'est qu'il est a moitié prix du netgear. Le sav netgear ne comprend pas pourquoi leur switch n'alimente pas assez en puissance mes caméras. Bref bravo Mokerlink ! et netgear arrêtez de dormir sur vos lauriers et faites évoluer vos switchs.