Audio-Technica AT8415 Microphone Shock Mount | Vibration isolation and noise reduction with universal microphone grip and adjustable tilt

Works perfectly. Super versatile and works like a charm.

Product arrived in a timely fashion. It meets expectations and appears to work well with the microphone and boom mic attachment. Only used a few times to date, but again appears to be meeting my expectations.

I needed a shock mount for a sensitive microphone. This one is sturdy and works very well. I use for bird recordings and have found it to be rugged enough for field work.

I have a Rode Procaster. After around 10-15 minutes, some sweat, & elbow grease I was able to get my mic into the mount. I had to take off some of the bands and reapply them to make it fit, but it’s snug in there now. Not taking it out any time soon, that is for sure. No need to crossover the bands like others have mentioned elsewhere - but it highly depends on the diameter of your mic. The Procaster is on the bigger end of the specs that actually fit this mount, and it was pretty hard to get in there.

Very fast! Love it!

Debido a que estaba en un sobre de burbujas, el envase de plástico que protegía el soporte de micrófono vino chancado. Eso no me agradó, por que pudo haberse dañado el soporte.

I own two of these mounts. They work really well, they hold the mic and don't introduce any noise. My customers like my sound work, so I'm happy as well. I use these with a Sennheiser mic. It's a bit narrow so I criss-cross the first set of bands and it works just fine. If I don't, after a lot of handling the mic will slip through. Keep a set of replacement bands on hand. I've had one pop and I had to use a spare rubber band from the newspaper until I could order a new set of bands. Replace them all at the same time and keep the others for spares.

This came in yesterday and I use an AT8035. I didn't have a shock mount so you constantly heard me handling the boom pole. I looked up the recommended shock mount on AT's website and this was one of two, the other would probably hold better but a few reviews said that noise came through... So I just cris cross the rubber band on each side and it holds really well. The mic wanted to slip down when I didn't do this. Still highly recommended. it seems to be built very well.

ガンマイクAT8015に使う予定で購入しましたが、取り付けてみるとガンマイクが長いので、先端が下がってしまいます。ゴムの本数を増やせば下がるのを抑えられますが、本来の目的の床振動を抑えられません。AT8015には不向きと破断し、別のガンマイクに使用しました。短いガンマイクならば、良く振動を吸収します。