LANSCOERY Acrylic Display Case, Assemble Showcase Display Box for Collectibles, with Dustproof & Seamless Display Design, 7x6x10inch Black Base

I've gotten over a dozen of these for my figure collection. They're easy to assemble and look very clean when assembled. I received one with overly brittle plastic that cracked during assembly and the seller immediately provided a replacement.

Sadly I cannot review this case positively. I was hoping this would work out as I've put together similar cases that were smaller before. This time it hasn't. I purchased the 29-inch size. At this size assembly is way too unwieldy and difficult for this type of case. In my opinion the slotted assembly approach for something this size also puts the collectable to be encased at risk due to the flimsiness of the case. Also, when opening the box and starting to prepare the acrylic panels, the film used to protect them was incredibly difficult to remove. Every acrylic case always comes with film protecting it, but I've never run into any as difficult to remove (and I have a LOT of cases).At a smaller size these cases may work out better, in this instance I'm very disappointed and will be putting the case into the plastics recycling bin.

For the price, these are decent little display cases. If you have the room and alot to display, you'll want Detolfs or Moducases for your collectibles, but if you want something smaller to display 1 - 3 pieces somewhere where dust could accumulate like the top of a bookshelf or desk etc. these are perfect. The clarity on the acrylic is very good, its rather sturdy when fully built and i like that theres no extra footprint unlike something like a basketball/football trophy case.What I didnt enjoy was putting it together - the acrylic walls and floor are covered on each side by a protective film that is quite finicky to peel off, even with the included circular piece that is there to help you remove it. Just getting all the film off will take most a good 15-25 minutes. It did have a pair of white cloth gloves that prevent leaving fingerprints but at the same time they make the precision needed to remove the film more cumbersome.I also quite like that the top lifts up rather easily so you can reach in to add or remove stuff.All in all, as a collector with a nice hooked up detolf display, coming down to this to keep a few things on my desk free to dust was a solid purchase. Just be careful when setting up not to scratch the walls and keep a microfiber cloth handy to remove any fingerprints as they will show up, you can use water with a bit of mild soap to clean it so its not hard to maintain either.

Product has to be put together. It’s very simple but be sure to use the circle thing to remove the protective sheets. I failed to realize this does not have a door on it so in order to put the figure in or take it out I’ll have to remove the top. It is not permanently put together. The sides fit together like a puzzle piece. They fit in not lock in. The corners do not come together either. The top and bottom are bigger than the sides. Think Lincoln log corners. The product will look scratched up when you take it out. Once you peel the film off both sides all the marks are gone. The box this came in was utterly destroyed but under the films on the acrylic itself no scratches at all. Comes with gloves to wear while assembling to prevent fingerprints, a cloth, and the circle thing to help get the film off. The film on the bottom piece is brown unlike the rest. I chose to keep it on as it reminded me of sand (which would work well with the figure I’m putting in it)

Worked out for my wife’s china doll she’s wanted to display for decades. Small crack around one of the corner pieces because I pressed to hard the wrong way. All in all it worked out. It is cheap and overpriced. However, they do throw in a string of pretty lights, polish rag and pair of gloves for handling.

I needed a display box for a new figurine and this looked fairly decent compared to others I've looked over on Amazon. I have 2 complaints with this type of display box which is that the protective adhesive on the panels are extremely difficult to remove with the tool provided. I wish they just had tabs attached to the adhesive to make it easier to pull off. The adhesive on the base however was the absolute worst to remove. It has a low quality masking tape texture which tears easily upon adding a small amount of pull force during removal. This frustrated me to no end but luckily I got everything off.The last complaint is that the slots are a bit difficult at first to slide into when assembling the panels. I managed to slightly crack one but thankfully its no bigger than a few millimeters. Once assembled the box looks great and functions as intended. I personally would only use this as a temporary solution or something for non valuable/exclusive figurines. I'm definitely going to invest in something better for my future figurines.

I had a great experience with this seller! After a small issue with the first product, they promptly sent a replacement—no hassle at all. The second one arrived quickly and was perfect. Assembly was super easy (honestly, removing the protective film was the hardest part!). The quality was excellent, and the customer service was top-notch. I really appreciate the fast support and follow-through. Highly recommend this seller and their products!

First of all, you better allow an hour to put this together, because most of the time is spent peeling the film off the panels. Better have strong fingernails to do this. Then a lot of time is spent trying to keep the panels from falling in, or trying to get them locked together. Once you have done that, look at all the dust that has clung to the panels! Who wants to start out with dust inside? Time spent on trying to wipe the dust out, while the panels would come undone, another 15 minutes! Never could get it all out. If you plan on displaying something heavy (like I was), DO NOT BUY THIS FOR HEAVY ITEMS! Waaaaayyyyy to FLIMSY! Make sure it fits your item, because once you peel the film off, you can't return it. Definitely not worth the money, or frustration putting it together. DO NOT RECOMMEND BUYING THIS PRODUCT AT ALL!