YESWELDER Tig Welding Torch WP-17FV Gas-Valve Head Flexible Head Air-Cooled

Worked for Eastwood tig 200. My old line was dry rotted and I wasn't aware. It was leaking enough and eventually started blowing up my welds. This was the best priced replacement on the market. I wouldn't hesitate to buy it again. I only wish it was identical with my original setup. I had to transfer the electronic switch to the new line, and open the valve. Works fine.

Very good quality.

I had the same hesitation you have right now. Too good to be true is all I could think. It works perfectly, and in all sincerity it’s my favorite torch in a shop full of Lincoln, miller, Ck, and several others. Doesn’t overheat any faster than the other more expensive air cooled options. Solid torch, don't be scared to try it! Save some money and thank me later. I’ve had it for a few months and still going strong after being used and abused by beginners the whole time.

A lot better quality than I'd expected for the price. Easy install and use...although Lift TIG is never the easiest. Good buy.

No setup instructions were included.I am a first time inexperienced welder and rely heavily on instructions and how to articles.I believe this item to be a great value for the price

I’ve not done a ton of tig welding but haven’t burned it up yet. Really liking it.

Works, decent quality. Flexible head way to flexible for me, takes little to no effort to bend head so often find it slightly out of place from time to time. Noticed my gas was running out quicker than it should have decided to leak test it and found 2 leaks a major leak around the thumb valve (replaced to a spare weldcraft valve) and a minor leak at the electrode grounding section at the threaded connection under the shrink wrap ( 1 side of the half cup is out of spec, had to install blue thread tape to seal it. re-tested everything. now its all leak free.

Not sure if I like the flexable head but works good. Hoses are flexable in cold Temps and I do like that.