KARPAL Hood Molding Trim Moulding Chrome Compatible with 2010-2016 SRX 22774203 GM1235120

Decent part, easy to replace. Good fit and finish. Added this tape (https://www.amazon.com/gp/product/B0CM5K4R5T) around inside of top of strip to duplicate the original and keep the edge from scratching the hood paint. Had to trim 1mm off center guide piece with Drexel tool so it would fit rectangular hole in the hood.. Came with new screws, but had to re-use old nuts, which was fine, 7mm. Put a small dab of E6000 adhesive around flat head part of the screw before sliding into the clip on the trim. Be sure flat on screw slides in fully square into the clip Added small drop of medium strength blue thread locker to nut before lightly torquing in place. Last steps done to add a little more staying power for the new trim, and maybe keep the clips from breaking on the new trim. Once in place, looks great on our 2012 SRX.

Looks good perfect fit easy installation

A wonderful replacement - fit the need perfectly! Once I figured out how to do the replacement process, it just was so easy to do. The value was great, also!

Quality is great direct fit

Looks good on my car, I’m happy to have that fixed. Like others said, this part only comes with the screws and no nuts and no instructions, though it’s not too hard to figure out. Unfortunately, I wasn’t able to use the screws that came with this as they were impossible to fit into the slots in the part. I ended up using almost all the original hardware and still had to use pliers to get the screws in the slots on the part. I was able to use one new screw because part of the slot was broken and needed the tighter fit of the new screw. Overall I’m happy.?

Fit perfect, good quality, easy to install.

Great fit 2012 SRX

I constantly buy stuff from Amazon so I’m writing this to let you know that this is a MID product. It fits! Don’t get me wrong this will work BUT the mold of the plastic is very subpar and I had to scrape parts of the plastic which hold the screws in order for them to click inside. It is sturdy… sure. But the mold is just alright and I had to spend 20 minutes correcting something that should’ve been already done for me. Photo is attached (the close up photo which shows scratch marks because of the scraping I needed to do). Additionally, the angle wasn’t entirely fit for the angle of the hood, so it had to be bent to fit (photo attached). Don’t know if that’s supposed to form like that. I purposefully bought this Amazon product because it was more expensive (and expensive always means better quality) and it still turned out not that great. I would suggest another option. But it works so 🤷‍♂️

Orderd this as it had the square head screws that attach the trim to the hood. Used a 10mm socket to remove the old hardware. The slots that the screws sat in were almost all broken. Removed old trim, used 6" adjustable to hold the old screws and removed the retaining nuts (6). 2013 and in Canada, used this opportunity to remove all the old rust, sand smooth, primer, paint and clear lacquer. Used the screws that came with the trim and the old plastic (acorn) nuts. Easy to install and fit perfectly. Very careful when tirquing up the fasteners to not snap the trim slots. Looks great. To just replace the trim will take about 30 minutes. Body repair and paint 6 hours.

muy buen producto

Great fit

très satisfait pour le prix. Conforme à l'original à peu de coût. Lustre impeccable.

look and fit were perfect