Sensor Extension Cable for Raspberry Pi Camera Module V2, 300MM/1FT Cable to Extend IMX219 Sensor for Smaller Enclosure, Narrow Space Project, Work with V2 Camera on Jetson Nano

Great

The 1st thing you need to know is this cable is only compatible with the imx 219 chipset. so if you have a pi camera module 3 then this is not the cable for you. There is one on amazon, but it is not available at this time. when connecting this to the camera board. the camera riibon (this one) should go towards the data ribbon that came with your camera. the camera connector should be strait out from the camera. oh and just to help the newbies. dont forget to add dtoverlay=imx219 to the config file.

I was looking for this but have yet to actually use it properly though. It's really thin and compact as it seems. Although I do wish it were white due to my project possibly overheating idk maybe I'm overthinking it. I hooked up 2 diffrent camera types to this. 1st is the one I think in the picture, a Raspberry Camera V2. 2nd is the Arducam Autofocus the little silver one. Both of these detach from the main camera component, u can then attach it to the ribbon cable. A nice piece to prototype with that allows a few types of Arducam to hook up to. Very good for robots for sure.

I ordered this extension cable when I purchased the https://www.amazon.com/gp/product/B08RHTG845/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1 camera. It does NOT work with this camera. At first I assumed the cable was defective, but after receiving a replacement, it still does not work with the autofocus USB camera. I have not found any other extension cable for this camera. Without the extension cable the camera works fine.

I get that these cables are delicate but out of package, neither worked. For the price of these, I'd reconsider the gamble.