BRIS Stainless Steel Boat Transom Launching Wheel Dolly

Comes with metric bolts for mounting so I replaced them with standard. But they are well built and they worked great.

It's a little hard to get the pins in and out, but otherwise does the job.

Good quality, but not a great design. I like the fact that the wheels aren't pneumatic, and the size is good for most terrain. However, the pins to keep the wheels in either the up or down position are not easy to remove, and even harder to get aligned when putting them back in, since there's no kind of guide inside the wheel support. Especially difficult leaning over the back of your boat. If you want to modify these to make that work more easily, then these are a fair bargain. If you don't feel like doing modifications on them, you'd be better off buying one of the other styles with the "slip joint" style operation. I plan to keep them and modify them to that "slip joint" type by just elongating the center pivot hole on the wheel support.

Those transom wheels carry my BRIS 9.8ft inflatable boat. They are easy to install, very sturdy and can carry my boat, my Tohatsu 6hp and all my gear (about 200lb). Of course, the wheels do not carry the entire weight, I carry about 30lb when lifting the boat on flat surface. I sometime use a 40 degree boat ramp, and can launch/retrieve my boat easily. Once on the lake, I never keep my wheels up, but remove them to move their weight to the front of the boat. The wheels are easy to remove and install back. My pins are securely attached to the boat with fishing wires.

Stainless Steel. Boat. Transom Launching Wheel ist very good..

With the pics available on line at time of purchase, these were exactly what I was looking for. That said, once installed, a different story. The supplied bolts are fine thread, very easy bind up when tightening. Snapped two, had to replace. When launched and with the wheels folded up, the center pivot pin employs a design that allows the retaining tab to fold in by itself, causing the pin to be lost and the wheel mechanism rotaed down. Learned that while underway as I felt drag. A small plus is the packet included 2 extra pins (used to latch in the up or down position). I replaced the center pivot pins (including the one lost) with stainless bolts and lock nuts, and use the other pins as advertised. To add insult to injury, the blue synthetic wheels collapse in any heat and roll off the rims! Also, if left to sit on the hard, they create a flat spot. This 10 1/2 foot Zodiac weighs 60 pounds, and the Tohatsu 8 hp outboard 80. Virtually no weight on the transom other than the outboard. I replaced the blue wheels with tubeless tires used for a handtruck. Not plastic or stainless, but I'll have to live with it. Very, very disappointed, to say the least.

Working well for launching boat. No instructions for installing.

Installed these on the transom of our inflatable Scout365 boat, easy to install, fold up or pull the pin and remove. I like to fold them up and leave them on the transom so they don't walk away. Makes transporting the boat over roads, gravel, or sand a much easier task.

Good item.

Used this on a 12ft job boat great sized and fit.