Silco Incorporated RTV 6500 Sil-Bond 2.8 fl.oz High Temperature Silicone Adhesive, Red (2)

I needed to seal the weather collar on my newly installed steel chimney so that nothing leaked down into the attic when it rained. I slapped this stuff on with the tube and angular cut tip. It was easy and effective. The remaining goop I used to seal the leaks in my shipping container which gets SUPER hot in the sun. So far everything remains tight and dry. And I still have a whole tube left.

Used on fireplace trim and holds up well so far

Used to reattach felt strip to dryer lint trap. Has gone through several high heat cycles and still firmly attached.

Sellador en desfogue de horno, se utilizó para sellar la junta entre tubo y teja, para evitar fuga de agua lluvia.

It held the felt lining to the drum. Good quality.

the smell is awful and probably toxic. i saw many you tube videos using this to seal the wick to the bottom of candle containers. even a little amount and it doesnt ever get that dry feeling, its stays sticky, I did a test run on a candle after the wick dried for several days, I poured white wax. The top of the wax has a faint red appearance because the sealant that is supposed to be heat resistant is bleeding into the wax. and i barely used any under the wick clip. Im sure since its toxic then im breathing toxins too. just a bad idea I think, I think i will try hot glue instead

Used it on my smoker. Sealed it up great.

Used to seal felted for dryer dried fast and still holding up well