Hamster Cage Chewproof, Large Hamster Cages and Habitats, Openable Top with Acrylic Sheets, Solid Built

Great enclosure for many types of small animals. It is extremely well made, absolutely HUGE, and easy to put together following the instructions and common sense. Everything I needed was provided. The bottom and top are made of a waterproof, light colored laminated wood material. The front and sides are a thin clear sheet of plexiglass. (Or similar material). They come covered in a scratch proof peel away sheet that needs to be removed on both sides juat before applying- watch the static go nuts! . It WAS difficult to put in the screws on the hinged lid, but the starter holes were properly placed and I finished the assembly using a friend to hold the pieces while I put in the screws. There is an additional thin flexible clear plastic piece that runs the length of the bottom covering the wood, so any water or urine won't ruin the enclosure. I worried my (male) Syrian hamster would chew the 4 thin woodstrips on the inside edges that were used to frame the bottom and sides, but it hasnt been an issue. It would be easy to replace that trim if damage did occur there. Look at the dimensions, they do come in several sizes- and the largest cage is extremely long- which is great. My Syrian hamster has lived in this for several months, and he doesnt run on his wheel because he has so much room. Ive seen people complain that the front plexiglass is flimsy, however, as long as weight isnt applied, it's plenty sturdy. I think that helps actually bc when something/someone bumps into it it flexes instead of cracking like a harder thin plastic might do. It did NOT come with child locks as shown in some pictures, but those can be found in many stores in the baby section. Cleaning is easy through the large top opening, snd the ventilation hasn't been an issue. We do have the top open for awhile every day when at feeding, sand bath cleaning, and hamster playtime. Its a well made and good looking enclosure, made of sturdy light colored laminated wood & plexiglass, and makes for an EXTREMELY happy Syrian Hamster.

I purchased this for my young female syrian after she showed signs of extreme unhappiness in the 50 gallon bin cage she was living in as she grew up and became larger. So far this has shown to be an EXCELLENT upgrade for her and quality product in the 4 days she has been in it. The assembly is really quite simple. During assembly I was worried about the sturdiness of the product but it does all come together nicely and is definitely a quality product. The front acrylic piece does wiggle a little but it truly isn't an issue, and in my experience so far the more bedding the firmer it stays in place which works great for me. The lock is comes with to keep the lid down is definitely bad and I am unsure why it only comes with one lock for one side. I purchased a 2 pack of baby locks on here for 5 bucks, which is a MUCH better solution. So far hammy has shown no interest in the top of the enclosure other than a few sniffs, but I'd say baby locks are definitely the best way to be sure no escape attemps will occur. Several reviews here say there were no holes drilled into the wood. What I experienced was there were, but they were very shallow. It was enough where I could get the screw into the hole but I had to put a lot of elbow grease into getting some of them properly screwed in. Overall though it wasn't too much of a pain. Everything was in good condition. The cage LOOKS absolutely gorgeous and has ample room for all her enrichment. I love how it looks and I love how quality it feels. It's lightweight so I reccomend this over a 75 gallon tank. For the price point and aesthetic look this is an absolute steal compared to niteangel enclosures (I love their products but this is the same quality at a great price for what you are getting). It is pricey but out of all the options out there, it comes out to one of the more affordable properly sized enclosures for a syrian. I am not seeing much opportunity for her to chew through this other than the wood encasing the plexiglass windows on the side. She has shown no interest in it thus far, but I can definitely see it being an issue if you did not provide enough enrichment for some reason. I will update if this ends up being an issue for us when she goes into heat next, but as she's never been a huge chewer, I feel it won't be a problem, and that's my only real criticism of this enclosure. The space on the top with the vents provides some space to place a little decor as I did, but I definitely would keep it minimal as to not block off air flow and ventilation. Since putting my hamster in this cage she has displayed zero signs of stress and is clearly much happier which makes me happy and this purchase 100% worth it, and I'm looking foward to it continuing to work for us long term. Overall as of now I'm very satisfied and reccomend the product :) EDIT: I had to move across country with my hamster which took 5 days and I had to take this cage apart since it was too big for the car, it was banging around under all my stuff for days and went back together with no issues and no damage when I arrived. For a piece of Amazon furniture I absolutely didn't expect it to. Just reinforces this cage deserves 1000/5 stars lol.

You name it, I've had it. Niteangel, Preview, Ferplast, Detolf, MeWooFun, etc. I've used them, adapted them, loved them, hated them... But this one might be the best. It's not perfect, but it is soooo close and easily one one of the top commercially available cages on the market. First, it's very lightweight. If you're looking for solid wood, you won't find it here, and you don't need to. The bottom and sides are a very lightweight engineered wood product covered in a waterproof laminate. One of my few complaints is that this laminate is quite thin, but it thanks to being well-packaged, it arrived with no cracks and wasn't damaged in the course of assembly. Assembly, by the way, took five minutes. Well, it would have if I had not added wheels, which are not included and there are no predrilled holes for them, but they were very easy to install nonetheless. I didn't even have to drill holes. I just tapped each screw with a hammer so it pierced the laminate, and then they went in easily with a screw driver. I would not use a power driver if you decided to add wheels. The rest of the assembly is just six bolts on the bottom to hold on the side panels. The front and pack panels just slide in to grooves, and then the whole thing is secured with the ventilated too, which is held in place by four bolts. Some may argue that the ventilation could be better, but it is adequate. The acrylic for the front panel and lid is a nice, sturdy, 1/4" thick, and a good weight to keep escape artists at bay. There is a version of this cage with a framed lid, which might make some people more comfortable, but I prefer the uninterrupted visibility of this enclosure. If you worry that your ham could escape, you could tape or otherwise secure the corners, or make sure the bedding isn't too high in the front. So far I haven't felt concerned. The front panel does bow out slightly with pressure from bedding inside, but it doesn't go past the edge of the lid, and I really packed it in tight when I was filling it. The only real potential issue I have with it is that the side panels are held in with several strips of the laminated board, and I would prefer it to be seamless. This may be an issue for a really avid chewer, but aside from female Syrians, that shouldn't be a problem as long as you have enough enrichment. By the way, I wouldn't put a female Syrian in anything other than the large, and I wouldn't put anything in the small. The medium is totally fine for all other hamsters. Overall, while no cage is perfect (except some DiYs), this one is, in my opinion, the closest to hitting the mark, which is why I'm giving it five stars. That, and because it's absolutely gorgeous. The previous reviewer gave it one star because it's "just a box" and doesn't come with accessories. I don't really understand why he thought they'd be included, but even being just a box... what a box it is! If you're looking for the best intersection of style, function, simplicity and price, this is it.

I purchased this product in 2024, and I have had two hamsters (Syrian and Russian Dwarf) use it so far. With the Syrian hamster, this habitat was too small and my hamster would easily get bored/discontented with it. She started chewing on the floor/walls in the corners of the habitat. However, she was unable to do any damage to the habitat which shows that this habitat is very well made and can withstand 1.5 years of Syrian hamster chewing! With my Russian Dwarf, this habitat is the perfect size - he never gets bored and loves all the cute accessories that fit in this habitat: I am able to fit a large platform, large standalone wheel, wooden bridge, hideout, and sand box in this habitat. I can also fill it with sufficient bedding for my hamster to burrow and tunnel. The habitat is a good size for moving it (can fit in the trunk or back seat of a car) and it can be easily carried by two people or one strong person! The habitat came with a plastic clip lock for the top door, which has continued to be sufficient for keeping the door closed and neither of my hamsters have been able to climb the wall and escape, however, I do have to make sure to not place any tall platform where my hamster could easily reach the door and push out. Overall, I love this habitat and recommend it for anyone with a Dwarf size hamster! For a Syrian hamster, a bigger habitat would be better since Syrians need more room to be content with and avoid boredom.

i 100% recommend this cage! it is absolutely beautiful and a great size for any hamster. the wood is very nice quality, it’s very easy to access and setup, the lock it came with keeps the door shut very well, the tall enough to have the minimum of 8 inches of bedding, and best of all my hamster loves it! it’s cheap for how great it is and i would definitely get this if your getting a hamster! i have no complaints

Easy to put together & lots of room for dwarf hamster. Of course if you want to add lots of things, get the biggest one. This had way more room than the tiny wired one we first got. Love that we can see our hamster better too verses the cheap plastic/ wire cages. Wish they offered these in store, would had bought it. The only thing didn’t like was the lock it came with, difficult to close/ open & fell off few days later. Not really an issue if you don’t put anything too close to top. Eventually will find a better one later.

I mean it’s good but it came cracked on the lid it went together after being screwed but the lock is difficult to find out I ended up having to hot glue it onto the side because of user error but the glass on the front is very flimsy and I’m worried that my hamster will escape it came with one lock which it’s a good lock but I thought it should come with 2 I got the biggest size and it’s a really nice size it was pretty easy to put together but for the price I feel like it could have been made a lot better, I use a lot of bedding 2 85L bags and it’s just worrying that he will escape because the lid is not secure at all the lock helps but there’s still a gap and that’s very worrying especially because hamsters always will try and escape no matter what anyways I do recommend it but just be careful

We bought this 3 months ago for our new Syrian hamster. I feel like it’s just the right amount of space to have lots of bedding for burrowing and enrichment without taking up the whole room. I like the opening on the top, but wish the whole top opened easier, so I could get the platforms and hides in/out easier. It also doesn’t have a ton of ventilation. As long as we stay on top of wiping out our hamsters wheel (which he pees in) it’s not too bad, but occasionally you get a whiff of pee when you open the top. It is relatively easy to clean/wipe out. It is sturdy and durable, and the color is as pictured.

Not as it look like

Absolutely brilliant

A nice, easy to assemble kit but that is it really. There were a couple of screws that didn't engage into the wood correctly but just sufficiently enough to be okay to live with. I would say that there is a number of far cheaper options available that would do the job just as well at a fraction of the price. Okay but certainly not worth the £345 price tag. About half of that price would be better value.