2 Pack Universal Racing Seat Slider Track Set

Works great on my racing sim rig. It's quite a bit less than buying from a sim rig company and looks identical. Once adjusted correctly, the seat slides smoothly and locks in place without any play.

Fits perfectly

Bought these to install a seat on a go kart. They are solid but not the highest quality. The biggest issue is that the two parts, fixed and sliding, of each rail set cannot be separated. You have to push each to one end of its travel to put the fastener in the other end, then repeat the other way. There's really only fastener positions at the ends of each part, the fixed and sliding rails. Takes a bit of DIY to fit. And the instructions are almost worthless.

I don’t usually write reviews and when I do they’re usually bad reviews, but these sliders are well built, thick metal, and even hardware is good quality, I was able to fit them on my Sparcos with 0 issues . Don’t OVERPAY!! these sliders are well built .

Decent Installing these on my Acura Integra 97 alongside with Corbeau buckets was a bit difficult. You have to pinch the rails a certain way to ensure alignment. When it comes to sliding, it’s also slightly inconsistent, where you would end up spending 3 minutes finding the sweet spot of sliding the rail. Overall, solid, does the job but alignment and performance is sufficient

Ok, this is for the Jeep CJ Guys, incase somone planes to put these outstanding sliders in there CJ. They only fit, i would say a little bit, but once they are there I it Awsome. Precice Adjutment is Garnted, on both Driver and Passenger side. First you`d have to get seat riser bracket (passenger) that is about 25mm lower as the original CJ one, because of the Sliders ( 25mm high). You`d have to modify the sliders for the seats just a little, so that they`ll fit perfectly. Then you would have to bend levers first straith then about 5° to the opposite direction otherwise the interfeare with seat. On my seat riser bracket the holes didn`t match at the width, so i had to weld the nuts that came with the kitt to the seat riser. Now it is perfect to slide the seat back an forward, if i need to. Same think is done to the driver side, first i Shortend the Risers at about 25mm ( not neccesery ) but alot better for comfor seating, then weldet the nuts on the riser brackets. The Oringinal sliders has only one locking side, now i have two locking sides, alot better.

Life saver. Now I can switch positions for different types of racing and my short friends are now able to use my Sim rig lol. The only downside is I wish the adjustments were a little bit smaller from one position to the next is a really big difference, but it still works great

Quality of the product seems great. It comes with all hardware, which is also great. My 1 star is due to the fact that the item will not fit a Sparco R100, even though it is listed as working for Sparco. I don't know if it fits other models of Sparco race seats but it did not fit the R100.

I installed a set on my dune buggy. The seats were directly bolted to the floor when I purchased the car. The slider seat tracks took some time to attach to the seats and floor. Once mounted they function smoothly and provide the needed room to enter and exit. They can then allow movement of the seat to a comfortable driving position.

Buena compra

I bought two thinking that I'll fit my Recaros but i ended up getting original Recaro sliders so do measure your seat widths.

Great product. Good instructions. Screws were a bit too long but easy to find replacements. Little tough initially sliding but loosens up.

Perfect for your simpit :) I use one of these for my seat in my sim rig and use another for my pedals so that I can slide them back and forth. Works great.