VEXUNGA 35uF 35 MFD 370VAC 440VAC 450VAC 50/60Hz CBB65 CBB65B Run Start Capacitor for AC Unit Fan Motor Start or Pool Pump or Air Condenser Straight Cool

The media could not be loaded. Very good . I never put one of these in my first, My original was not marked so I followed the wire colors to figure out what was what. I was a little scare ( woman here) but kept going forward. I watched several you tube videos prior to purchasing and installing. I did not get a shock and my unit is so quiet and efficient now. I didn't know that if your unit gets loud you probably will be needing one of these soon. I have 4 compressors at my home and this one was the noisest. Anyway was easy, clean up everything, tighted up all the nuts and its good to go.This heat pump was installed on my home in 1995. They were built to last.

Great product....fit and does what it is supposed to do. For half the price....came in clutch fan wasn't working on AC unit, watched a quick YouTube video ordered capacitor over night and was able to fix unit in less than 15min.

Arrived as advertised, install took 15 minutes with slight learning curve for this model heat pump and it fired right up as it did two days prior!Thank you for making a quality product and it hope the long term review will reflect a decent life span!We have many 'brownouts' and had another AC unit for out next door 36 hours prior to this one. Dirty grid power or regular outages of 5+ seconds are very hard on capacitors in air conditioners!I was curious so I looked into it and ~83% of all HVAC related service calls are capacitor related...I bought two for each unit so we have one sitting in the storage room to use as a quick fix next time one goes out.It is not about the quality of the capacitor as it is the amount of abuse the component takes.Signed of poor construction are barely starting the motor from day one to swelling of the can which indicates it was barely staying sealed when the insides want to blow up.The welds are great, can is clean, connectors are strong and sized properly.It provides the needed burst of energy to get the compressor running and I hope it continues for a long time to come.Best wishes and I hope this helps.

Watched a YouTube video of the most common Central Air not working fixes. I went out and checked mine as it has not worked a couple of years. Sure enough, the main fan was working, but touching the compressor tube, you could feel it pulling every second or so, but not starting. Removing the old part and measuring it, the fan side was good and the compressor side was bad. Watch some YouTube videos if you dont know how to do that. It's not difficult.Anyways, after kicking myself in the butt for 5 minutes straight, I ordered a replacement here on Amazon. Product arrived fine and appears to be a well built part.Steps to replace it:1)To start, most units have an outdoor circuit breaker you can pull to de-energize the unit. Pull that and/or flip the switch for the CA unit in your main fuse box. Next, remove the side access port on the outside unit, usually just two screws to get access to where the starter cap and relays are.2)Checked the old cap to make sure it was de-energized (Very important step!!!). Do not touch those wires if it's still energized! If the unit is truely powered down and you still measure voltage on the old cap, you may need to discharge the old cap. Remember though, there are TWO caps in one and you need to discharge BOTH. If either still has a charge, they could give you a serious bite. Not to scare you away from doing it, you just have to be safe.3)Marked the color of the wires and where they plugged into on the old cap. Note:Take a couple of pictures of the old cap and what wire goes where on it. This can be good to reference later!4)Unplugged all the wires from the old cap and loosened the strap holding it in, and removed it.5)Fit the new cap in under the strap, tighten it down but not so tight that it could dent the new cap, and plugged the wires into the new cap in the same positions as the old cap.Note: In most cases, the compressor will plug into the terminal stamped HERM. The fan goes to Fan if stamped. There are often two wires that were on the same terminal on the old cap, and that is the common. Plug all the wires in and DOUBLE CHECK you did it right. Take a picture of the old one at the start if you're not sure.6)Put the side access cover back on the unit.7)Reinstall the circuit breaker. Set the thermostat to turn it on and hopefully you have nice cool air blowing in a few minutes!8)Especially if this fixes it, a very important step is to order a second cap!!! Then you dont have to wait long if it goes out. These get stressed every time the fan or compressor turns on. They do go bad eventually, so just have a backup ready. You will hopefully get a good 3-5 years out of the cap.In the attached picture, the temp was 78, now 71. Spouse and kids are happy. Therefore. I am happy.

So far it is working good 👍🏼

Fast delivery and capacitor worked perfectly. Some reviews said they didn’t last long but so far all is well and the money you save by using this capacitor and not having to pay for a service call for an AC company who would also charge you labor and a restocking fee make this item priceless. Capacitor seems well built. Time will tell. I bought 2 just to have a spare for next time.

Worked and fit perfectly! Installed it in 10 minutes and AC turned on immediately.

Performed as expected. Excellent. Solved my compressor failure issue.