Review for: Ringke Onyx Case Compatible with Samsung Galaxy S24 Ultra Case (2024), [Compatible with MagSafe] [Firm Grip] Non-Slip Anti-Fingerprint TPU Shockproof Cover - Magnetic Black The Good: ‐ The Grip. The grip is great, the texture is enough to grip the phone but not enough to feel rough and sharp. The Corners and Edges: They take the sharp feeling away that comes with s24 without a case. They could be a little smoother on the edges and corners since you have a weighty phone resting on its bottom corners and edge on your fingers. They are still good on this case but could be an issue for sensitive/ softer skin types. Magsafe Charging: It works. Both horizontal and vertical. Doesn't effect the Spen (off of a The buttons: They work, reposive,easy to press.no issues .Just like using the phones buttons. The unknown, I can't tell you how good the drop protection is as I'm not going to test it for a review of a £20 case. The Bad: ‐ The Magsafe ring feels very last minute and "How can we change our case quickly compete with the competition". The reason for this conclusion is because the ring is essentially sticky taped down inside what is suspected is the orignal (non-magsafe) version of this case. If you press the ring inside the case you can hear amd feel (on mine) that the it's just tapes down. Because you can the tape is unstuck in places. I could get a replacement... but the fact is still there. It's just. taped. Down. How long that will last when being magnetised then pulled off off constantly , charger , car holder, desk stand. considering a brand new case already come 'unstuck' in places I don't think this will last long. You can also, ever so slightly see and feel the ring pushing through the back of the case (like it's not supposed to be there) ‐ The side ridges I feel are a little too high. Especially for a phone that uses side screen swiping, and even more so if you use Onehanded+. I mean it works... but you have a noticeable ridge to swipe over on every swipe. If I were to keep this case I would run a Stanley blade down the sides to reduce the height. That goes for bottom middle (swipe up) section. Camera holes: I would personally like slightly bigger holes. So that I could get some pop over lense protection on. Other notes: not so much a case issue but an inherent issue with the Spen design. When a magsafe case is connected to magsafe device the spen does not function correctly, you lose pickup around the ring area. This is likely due to the way the Spen is designed and works at its core. And probably the reason Samsung didn't ad magsafe to this phone. But off the device the pen works fine. The time in which I wrote the review I have felt the cases edge rubbing on my little finger, which the phone rests on. Long term that will definitely cause annoyance. Personally the Bad outweighs the good on this case. And I will be sending it back. The other option would be get a replacement and hope it's 'stuck down' better. The take a Stanley blade to edges to get rid of the 'side rigde', then hopefully that some fine grade sand paper can smooth whatever is rubbing against my little finger. Hope this helps .
