3000W Pure Sine Wave Inverter 12V DC to 110V AC with LCD Remote,6000W Peak

Bought the 3000w in Dec 2026. 3 trips camping for about 1 week each trip and at home testing etc. Installed with 1/0 cable. We will never use more than 2000watts from this install. Although I did test the ability of the inverter to do 2 min of 2800watts with no problems of voltage drop. The wire length from the inverter to the 365 ah of batteries is about 5'. That includes the bus bars, shunt and cutoff switch and 300amp fuse so lots of connections. Love the remote control panel. The standby current is less than 1 amp and 0 if turned off at the remote control panel. Our MW pulls 1200watts and my Keurig coffee maker pulls about 1500. I can run both if I want to. We have had no issues with this inverter. I have two battery banks. In the pic's you see only one battery. It is a 165ah 165 amp discharge max. Other bank is 200ah with 200amps discharge capacity. Have had great performance of this unit.

Wow I'm impressed, this will run a real 7 1/4" Skilsaw, has plenty of reserve to start a real construction Skilsaw at 1,800 watts start up, and up to1,000 watts at constant. Also will run any 120v compressor. I'm using a 200ah lifepo4 12v battery. This inverter Would have no problem also running table saws and chop saws. Everything within 2,200 watts AC 120v will run efficient. But you will need a much bigger battery bank if you want to run say a 1,500 watts AC for any length of time, more amp hour batteries will give you longer run times. I like the low voltage cut off settings you can set so you don't over drain your batteries. Nice feature and absolutely necessary. One thing I noticed, that the fans rarely come on. And they only run for a very short time. I was pulling 1,200 watts for awhile and no fans came on. This thing runs much cooler than my other brand 1,000 watt inverter, which shows this inverter is both effective and efficient. If You need more than 2,200 watts constant you should bump up to 24 volt DC batteries and a higher wattage 24v DC input inverter. Way more expensive, but you get twice the juice out of a 24v battery than a 12v battery and only using half the amps of 12v battery. Twice effecient over 12v. The AC voltage on this inverter stays high around 119v/120v AC. Which is correct AC voltage. Most Inverters run at 110v to 115v AC. Then they drop down more in AC voltage under high loads. Not good, but this inverter is good and always stays at least at 118v to 120v AC even under load. Higher voltage means better speeds and performance on AC motors and fans. This will also able to run 120v full size fridges, window AC unit or split AC, Skilsaw, wet dry vacuums, carpet vacuums, Carpet cleaning machines, air compressor etc. But Stay at the Maximum of 2,200 watts constant load, don't overload it. The max load constant of 2,200 watts dictates how many devices you can run on this inverter at the same time. Again Don't overload any inverter. Bad for batteries and wears out the inverter. This inverter has a quick surge capability of 4,400 watts. But only a few seconds, only for power surge start up on AC motors. But this can run constantly at 2,200 watts AC. Most people will be happy with this inverter, and it will run many of their AC appliances. Looks well made, with nicest remote display turn on off I've seen. Display is fairly accurate. We'll see if this inverter brand holds up, if it does I'm buying this brand from now on.

I was hesitant with this inverter because the price was so affordable. Upon receiving it and installing it, I have become impressed and feel like this might be a really good unit. Here is my rationale: 1. The buiild quality is superp... this is the type of device that is in a class above the typical heatsink-type inverters usually at this price point. This isn't a clunky piece of machined aluminum strapped to sub-par circuitry in an attempt to cool a cheap product..., this is a plate steel fan cooled chassis that is more common in higher end units. 2. The fans have never come on, even with extended electric chainsaw usage. That's a good sign if you can have it under sustained load with no fan cooling required. I am sure the fans will come on, and it may be a different story in the summer, but for now I was impressed. 3. Real world usage: My unit currently runs a deep freeze, a 1000 watt transfer pump, a 12 amp electric chainsaw, heats a pump house, and powers a few outdoor outlets... one of which I use for small-scale welding. So it has the watts, and it runs cool and feels solid. My only hesitation wll be time. Will it last several years under normal use? No way to tell, but I'm hoping we're off to a good start. I have need for 2 or 3 more of these, will report back if I buy again.

I've had this for 8 months. Runs the power to my tesla. Seems good so far

works well but the fan programming is a little annoying. On high. off. On high. Off. On high. Off.. would have made more sense to just keep it on medium all the time. Could be wired, but I don't feel like taking it apart

I've had this for almost a year. I have 0 complaints runs relatively quiet.

UPDATE 2 - April 21, 2024: All good now. My self installed inline 60amp circuit breaker on 4/0 cable feeding DC to inverter was interfering with the inverter's logic causing it to shut down after brief 1500watt microwave oven load. Breaker removed, new wire installed, microwave runs fine & long enough to cook. Battery to inverter 4/0 cable gets hot so I'm upgrading that to 1/0. Very impressed with customer service & technical support. They responded in less than 12 hours over several rounds of email with intelligent advice & guidance. Full understanding of the situation. Also very impressed with the 3000 watt inverter. I took the cover off and noted excellent build quality, four sets of two 40 amp fuses, solid component sets, assembly well done & secure. AC outlets where most of the wear/tear would occur are solidly glued in place rather than cheap tabs I've seen on other inverter units. UPDATE Apr 14, 2024: upgrading the review 2 stars as Oleantp responded with a potential solution within 12 hrs of my post. Kudos for excellent customer service. Will update further after I implement their guidance. ORIGINAL REVIEW; Oleantp, need technical support please. I recently bought & installed 3000w 2024 inverter. Connected to two new 300ah lithium ion in parallel 12v batteries. 60amp inline breaker to protect wiring etc. Batteries at 99%. Low draw led lighting etc work fine. Heavier loads like 110v microwave plugged directly into the inverter start up & begin to load the inverter. After 5 seconds the inverter shuts down. The inverter resets & comes back on as evidenced by 110v led light also directly plugged in. The microwave clock comes back on. Restart the microwave to heat & cycle repeats. I’ve tried this independently with 1100 watt, 900 watt micro wave & very small toaster oven. The inline breakers do not trip. The operating watts are well under the 3000watt rating & dramatically under the 6000watt surge rating. What’s going on here? I’d like a replacement inverter please.

burned up and took out one of my two mppt controllers and here was their response...LOL..when something cooks you replace it asap. Now read what they want to issue a refund. Its how they avoid the product liability. 1. Clear photos of the inverter, battery connections, MPPT controller connections, fuses/breakers, and wiring setup 2. A short video showing the current condition of the inverter, including the LCD/remote display if it can still power on 3. Your battery type and capacity 4. The total wattage of the devices connected to the inverter output 5. The cable gauge and cable length used between the battery and inverter 6. The fuse or breaker rating installed between the battery and inverter Since this is a 24V 4000W inverter, it must be connected to a proper 24V battery system with correctly sized wiring, fuse/breaker protection, and correct polarity. Burning smell or damage may be caused by several factors, such as reverse polarity, loose wiring, undersized cables, overload, incorrect grounding, or abnormal current feedback from other connected equipment. Once we receive the photos/video and system details, we will review the case carefully and provide you with a proper solution as soon as possible. Again, we are very sorry for the inconvenience, and we will do our best to help you.

Nicely made. Good quality Working well

Hi recommended very well made product.

Does exactly what you would expect - the part that I wish I knew (and several other reviewers have pointed this out) is that it is very annoying to have in any living space. The fan controls are poorly designed. On a reasonably summer day, pulling only 40W, the fan very loudly kicks in for about 1.5 seconds before turning off. This happens about once/minute which is jarring and disruptive. I will be exploring a small USB powered fan that can quietly pull a constant airflow that I can ziptie to the back of the inverter so I can keep the components at the right temperature without using the built in fan.

Well put together.