TwoTrees Honeycomb Laser Bed 300×300mm | Compact Honeycomb Working Table for Mini Laser Engraver & Cutter | Fast Heat Dissipation & Desktop Protection (Black-9)

Easy assembly works as it should

I recently installed the Titan Extruder upgrade on my CR-10 V2. Although it's a great direct drive upgrade, the amount of weight it puts on the hot end assembly is significant. This, potentially, can impact the acceleration and movement of the hot end, and therefore, 3D prints with a lot of angles. With this stepper, not only did it cut the weight by 2/3rds, it worked perfectly without me re-calibrating the e-steps! Now don't get me wrong, I plan to perform e-steps tuning, via Pronterface, to dial it in after I install the E3D V6 all metal hot end (with 3D Passion nozzle and heatbreak). Pay no attention to the cable management in the pictures since that is temporary. I'm designing a drag chain setup in Fusion360 to handle all that. Thanks! Updated: I added a heat sink (removed the included tissue tape and installed actual thermal adhesive tape) to the stepper motor since it runs a little warm.

Very nice starter laser i have 2 of them and use them all day everyday

1.5 A is too much for most hobbyist projects, but that is no fault of the part. Once I had a driving circuit designed that could drive 1.5 A the motors worked great and were also very accurate. From a hobby standpoint you should look for a motor that requires less than 500 mA.

Que viene desarmada y es un poco demorado el ensamble

The gantry stopped working after a few weeks of use some issue with cabling seems to have a short. I had contacted their support and they gave me ridiculous advice and runaround and never offered to replace the cable. Will never buy anything from twotree again. I had the same problem when I purchased their 3D printer stop working after a few days ...no support. They don't support their products they have a terrible website with very little to no information and no life support you have to wait overnight for someone to respond to you from China asking you for videos and emails of pictures that they never respond back to. It's too bad because they make a decent product but with terrible support. I'm going to stick to bigger well-known brands like creality

This bolted right up to my Ender 3 Prro. The plug is the same, and it matched the polarity that the stock stepper used. You may need to reverse the rotation in software, so heads up there. Otherwise, it's pulling filament from a curved Bowden tube that leads to the dryer box that I keep active filament in with no problem - torque is not an issue as I've used it. I believe it matches the stock stepper's step rate, as well. For eight bucks, I lightened up my print head plenty with no evident sacrifice. Cheap, perfect fit, plug and play, super easy install.

I like this. It makes so many different things with the wood

Cumple con su funcion y buena calidad

Se tardó un mes en aceptar el pago y otro mes en llegar, ha funcionado bien en mi máquina (tts-20 pro).

Ist in Ordnung ........

Works with Artillery Genius - but you'll have to save the screws from the former unit so that the circuit board has anchor points.

Defectuosa la cuerda de los tornillos, opte por no usarlas