SchluterDitra-Heat-E-HK Electric Floor Heating Cable Kit with Temperature Sensors - Ideal for Interior Tile Floors - Minimal EMF, Twisted Pair Cables, 120V, 212.9 Feet - DHEHK12064

My sense is this is a very well designed product, and a part of a really easy to use system. I understand the importance of the electrical pre-install checks and advise everyone to do them. It's doing the job I hoped it would, maintaining a nice even floor temperature using the Ditra-Heat thermostat. It's not inexpensive, but I think you get what you pay for in this case. Absolutely no complaints.

Don't buy to much!! Buy less than you need if you aren't sure and always measure the floor area minus 4 inches from the wall all the way around... We had to buy a second roll because we were over like 20 get off material and I had it tucked in there like a pro... Had to rearrange the pattern several times to make it work and the worst part was paying the licensed tech to come out before during and after the install to check with the special meter to get the warranty signed off. They have to push power through it with a special meter before it goes down to make sure the roll is good from the factory... Then during the install once it's down in the schluter underlayment to make sure you didn't pinch it or break it, then after the tile went on it... Real pain in the ass if you want that warranty but it works really nice in the winter

The schluter cable is a little thicker than other cable i had looked at and fits perfectly in the uncoupling membrane. It was easy to install once i had the layout but i did have to pull it a few times when i realized i was boxing myself in the oddly shaped bathroom. I chose the 64 sqft 120v cable bc i didn't want to have too much cable and not enough room to properly space. The first time I tested our heated floor it took about 15 to 20 mins to raise the heat tile temp from 62 to 70 degrees. It probably wouldn't have taken that long if I had the heat in the house turned up to normal 68-70 degrees. Great product!

Schluter is the only way to go for tile heating. The layout of the wiring takes a little planning. I used a sharpie on the schluter floor pad to mark it out ahead of time. This is a good price

expensive but you will love the warmth on your feet

Works as advertised. My wife loves the warm bathroom floor. Schluter's customer service was excellent for helping this very experienced do it yourselfer learn a new process

Although pricey, the ditra heat system is easy to install and customize as need. I am an avid DIY'er and this went from plywood to tile in less than an hour.( would have taken less if i didn't change my mind about heating locations twice during the process)

Fast shipping, great product

Great price and as described ...very fast delivery!