Neoprene Rubber Self Adhesive Sponge Strip 10mm (W) x 3mm (T) x 10m (L) | 3mm thick | For Sealing, Gaskets, Weather Strip, Cushioning, Noise Reduction, Anti vibration, Anti slip, Industrial & DIY

Just as good as original Denso tape works well

The item was delivered ahead of the estimated time, and is well produced; the release backing is easily removed when it needs to be, the neoprene is soft and pliable and easily bent to the line required. The advantage of the self-adhesive is of course that no separate adhesive need be bought. The product is exactly what I required and I have already successfully applied it to a test area and am very happy with the purchase.

I have built a small scale model Tractor and tyres posed a problem, I used this foam tape to wind onto the metal rim building up the profile to the dimension required, , then cutting small pieces to form the tyre treads, the appearance at this point was crude which is why I used the next purchase, self amalgamating tape, to tightly bind the foam, being self amalgamating it grips itself when pulled tight, result quite good, I'm happy

The quality of the packing caused a couple of deep creases that were difficult to flatten when stuck down.

I like this because very non slip which is what needed .thought I got a lot of it for the money and couldn't be any simpler to use

Good

I didn't use it for what it was intended, but it worked a treat! Used for making up the difference between thickness of tile and mosaic boarder on a wall. The mosaic stuck straight on top of this tape (with tile adhesive). The adhesion of the tape to the plastered wall was great. So it can be used for other things than fixing wet suits!

I used it on my car putting it in the area underneath my car roof rack where it touched the paint work. Worked okay but peeled off easily in the heat.

excellents

This is the highest quality rubber foam type product I've used. It is a neoprene/EPDM combination. I first discovered it bec it was one of the few offerings available in 1/16 in thickness (1.5 mm actually) and have expanded from there. Full technical specs are also available on Rubber Stuff's web site should you need it for your application. About the only area for improvement is that the adhesive backing becomes brittle after prolonged exposure to cold temperatures. It doesn't detach, but it makes clean removal very difficult. One tip though - Make sure you only buy from seller Rubber Stuff Limited. You will get the quality stuff from the UK. I once accidentally bought from a Joop food and got a much stiffer feeling product made in China.

I bought this to line the top of the roof purlins on our greenhouse before laying down the multi-layered polycarbonate sheets for the roof. It really helped to keep them from sliding around before I could get a screw into them. Then I used some to line the top of my pickup truck bed rails to help waterproof my tonneau cover and keep it from shifting around as much. Then I used this to line the top of the canister filters for our big aquariums. I was constantly battling leaks from those canisters (both Fluval and Eheim) until I tried this stuff. So far it has sealed all of them perfectly and no more leaks! I plan to keep a roll of this stuff around all the time. My only complaint with it is that the paper lining on the adhesive side sometimes rips and separates in places as you are peeling it off, but that is a very minor inconvenience.

used it on painted wood and the adhesion is very good

As others have commented the glue is pretty bad. For my application though the adhesive is basically irrelevant. The material is really more of a semi-hard vinyl feel than what you think of with rubber, but it is non-porous and nice and flat. Used it to insulate a fuel tank from the body sheet metal to keep pump whine out of the cabin.