Corp., 2602-1051-100, Magnetic Reed Switch/Sensor, Stainless Steel, SPST - Form A, 25W 200V 1A, Qty: 1

Actually, works better than I expected. I have tested it with several magnets and the sensing distance definitely is affected by the strength of the magnet.

It's rated 200V, 1Amp. I was assuming that in my circuit (120VAC, 350mAmp) it would work perfect.And it was. First 10-20 times. Then both switches got welded in Close position (making contact).If I made any mistakes I will give it five stars - it was perfectly working in 24VAC circuit but not in 120VAC.Manufacturer has 400V model too but now I'm not sure if it works on AC.

So you all know this is a form a Relay device. Meaning it’s a Normally open switch in the de energized state. Hope it helps please view my photo. Works as described using as a good latch contact with a molybdenum magnet. Works well.

First off there is no mention if they are a normally open NO or normally closed NC switch. Found out the hard way they are NO.Secondly they are not an assembly as described. The photo clearly shows the switch and the actuator and the Description clearly describes this as an assembly. However you only receive the switch in for an additional $19 you can get the actuatordescription clearly describes this as an assembly. However you only receive the switch in for an additional $19 you can get the actuator

I use this as a driveshaft speed sensor to read a flying magnet. It works perfectly

Work as it says it will

Great quality item well-packaged