PC Products PC-Concrete Epoxy Adhesive Paste for Anchoring and Crack Repair, Two-Part 50 ml Cartridge, Gray 70505, 2.8 Ounce (Pack of 1)

Normally you buy a whole tube. But unless you’re setting enough material, you have a lot of leftover cement that gets wasted. It mixes in the cap, hardens, then you can’t use the rest. This was Great for setting a few bolts or rebar for small projects.

I wanted to install a hook (to attach a laundry line) in a preexisting hole on the exterior of my brick house. I used this to fill in the hole and anchor the hook in place. this stuff is no joke, full load of wash hanging and that hook is solidly anchored. And I didn’t have to drill a new hole in the brick.

Works as expected. Masonry company didn't use as much mortar as I would have liked, totally my fault for listening to them (BBM) but this goop is the fix for now.

I have used this product several times to attach threaded rod into limestone, it works well and I have had no failures. I wish the operation of the mixing tip didn't use up so much of the product and that it flowed better.When I received this product, it appears that one of the tips had been removed prior to shipping ... bummer, someone is not paying attention...I had to order a pair of tip replacements.

When I purchased this product, I didn’t realize I needed a special pp-50 gun to properly dispense the product. After buying the special gun, I was able to reattach a broken off head onto a concrete statue.

This 2 part epoxy is ideal for fixing small cracks and foundation spalling on your concrete foundation.Precisely mixing the 2 parts together is challenging since it is a 1 to 1 mix it must be fairly precise when mixing it. I used a couple plastic spoons to keep them separate. One spoon is used for the epoxy base and the other was used the epoxy hardener. You must do this mixing process with extremely good air circulation. The hardener fumes are toxic so you will need to open the epoxy hardener container and stir it due to settling then put equal amounts of base and hardener in a small clean container and then quickly close and seal the lid on the hardener container. You can buy this same PC Concrete product in a caulking tube size that pre-mixes it and then dispenses it, but it would cost considerably more compared to these bulk containers. Once it is mixed you have about 15 minutes to apply it to your foundation. repair.

Used to make some small concrete patches at a commercial location that forklifts drive on this stuff hardened up overnight and still solid after a few weeks, good product!

Thought I would try this system of anchor epoxy and ended in disappointment. The first anchor took so much grip pressure with the mixing tube that it took almost 5 minutes just to squeeze enough material out. Decided that I was going to try hand mixing instead. Removed the mixing tube and the pressure was still very high but I tried to slowly push out the two materials, then a pop and the white material tube burst... even without the mixing tube. Either a bad design or the product I received was defective.... no date on the product but the outer package looked tattered and old. Either way I feel this product is not reliable and a waste of time and money. Purchased from Amazon one week ago. Tried another brand and had no trouble at all.

Matched color & ease of use

I ordered to fill cement cracks and low spots in garage. Must mix thoroughly and be prepared to use immediately as it sets within 10 min. So far so good. There was two of us working-one pouring one spreading.

Very good

A little bit expensive but its a very good product !!!

slow to arrive but fine apart from that!