JKS MFG. JKS OGS159 Rear Adjustable Track Bar for Jeep JK

The JKS rear track bar centered my axle after a 2.5" lift. Very easy to adjust, install and directions were simple. Really solid compared to the stock track bar. First JKS product but so impressed with the quality I'm sure this won't be my last.

JKS makes great products and pays attention to detail. This is a beefy trackbar and it was easy to adjust. I can't speak to the longevity of it as I had to return it. If you are using a stock trackbar bracket, or have a 3.5"+ lift I would recommend it. I tried to use it with my EVO Enforcer 3" lift and it unfortunately will not go shorter then a stock trackbar, which is what i need to recenter my rear axle.

Strong and easy to install

High quality

I don't know why everyone is saying it is too long. I have a 2.5" lift on my JKU sport. This fit perfectly. It was just too short when screwed all the way in so it fit perfectly once I adjusted it out a few turns. If you have any less of a lift, there really is no need for a new track bar anyway, so this should fit your needs if you have at least a 2.5" lift. Install is a little tricky, but that's no fault of the product. Just the nature of this install. The passenger side brake line was in the way when trying to remove the old bar. Just remove the 10mm bolt holding it to the frame right inside the wheel above where the track bar mounts for easier access. I also recommend loosening the bolt attaching the track bar bracket to the frame on the passenger side first to make it easier to remove the old bar and put the new one in. Had trouble getting it in around the rear diff. Install the passenger side first with nut just hand threaded on. Then you can swing the other end around the diff and into place, adjusting the length as needed. Had to tap the driver side end into the bracket with a hammer as it was a very tight fit. Overall, product fits, works and looks great, and install isn't too bad. The worst part is removal of the old bar and lining everything up.

4 inch lift on 35’s, stock brackets, easy install with plenty of room leftover for adjustment, solid sturdy bar and budget friendly

Great quality product from AEV. I had to remove my rear trackbar relocation bracket (AEV) as the trackbar would not shorten enough to allow for the axle to be centered. Works perfectly in the stock axle side mount location, and ride quality is only slightly affected. No clearance issues with my Poison Spyder diff cover.

Very well built. good fit.the only thing I did not like is that the Jam nut is big and located right behind the spring and in some cases it might rub against it (need to make sure the springs are vertical and if needed use alignment bracket)