Prime-Line P 7516 0.120 In. x 25 foot, Black Spline (1 Roll)

This .120 spline was exactly what I needed. It is a hard size to find in local stores, but it’s essential if you are replacing standard factory mesh with thicker pet screens. I tried using the standard .125, but it was too tight with the thicker mesh; this swapped in perfectly and holds great. High quality and works exactly as it should.

I have found that the recommended spline diameter can sometimes result in a screen that, while it will hold, can easily be pushed out of the frame by hand. A thicker spline is a BIT more difficult to install with the tool - you need to stretch it out a bit and/or put more pressure on the tool. But the result will be a screen that holds firm and tight. When doing your screen, work on a level, flat surface. It helps to have someone aid in holding the screen at one end of the frame. Pull it so it is snug and without snags, but be careful not to stretch it with too much force. The screen can tear easily if you over-do it. Remember, too, that that the movement of the spline into the channel will take up some additional slack. The nice thing about re-screening, is that it is very forgiving. If you are not satisfied, carefully pull the spline out and give it a second try.

I replaced the screen on one of my windows, as it had been torn by pets. This spline was perfect... it's a little thinner than the usual which was important because I was installing a thicker screening material in the door (which was advertised to withstand the abuse my cats give it). Worked perfectly and was a breeze to install in minutes.

Ok value however found cheaper ones after purchased. I bought the smaller size .120 recommended to use for pets screen per Amazon and it was a lil small. Should of stayed with standard size 140. The product is fine otherwise. Bought another cheaper larger spline works fine now. Nothing wrong with the spline itself was just wrong size they recommended.

Initially bought a kit but couldn't get the spline to stay in the RV screen door I was replacing. Some of my problem might have just been being a beginner but some might have been the wrong size spline. Did a lot of research and found this and New York Wire 70587 Pet D-Fence Screening, 36-Inch by 84-Inch . Several suggestions were to put them together and they worked great for me. If you're using a more normal screen, this spline might be a bit too small depending on the tracks around your screen, but too big is also not a good thing. A little tough to keep connected in the corners, but this with the pet screen worked great for my application. From two torn screens in an RV screen door to pretty great looking installation. I will be doing this again!

Really liked this spline when I was repairing my screen door. Because I was replacing the original screen with heavier material, there was less room in the groove. By tugging on the spline and pushing down with the tool, it was really simple to make it fit. Plus, once I quit tugging, it contracted to fill the space, so it's a tight, secure fit. Easy to trim the edge, and last but not least, getting 25' meant I had more than enough for this repair job and some left over for the future. Totally recommend this product.

I was installing Suntex 80 which is twice as thick as normal fiberglass screen. It requires the thinnest spline you can find to install in the frame (New York Wire 5/16"). Lowes had New York Wire and Phifer .125 (very slightly larger hollow core, more ribs, very slightly longer ribs) for about $4 a bag and it was hard to install. This .120 spline still was an effort to install but went in easier while still holding the screen in tightly. It was also half the cost. Before installing if you held the two sizes of spline side by side in your hand you would notice the differences. After installing you would need strong light and a magnifying glass to tell the difference. My only regret is that I bought 4 bags of .125 spline at before I ordered the rest online. If I had used .120 from the start I would have saved almost $10 and some sweat and effort. At the cost of starting the project a few days later.

Worked as advertized. Would have been easier to re-screen the window frame if I could have found the right tool which I own. But, did ok with a disk and screw driver.

the line is too thin,can not fit the groove well

I bought this spline when replacing the screen on a patio sliding screen door. Works as intended. I didn’t notice any obvious flaws or weak points in the spline during application. I also had a few feet left when done with the screen door which was nice, I’m saving it for when I redo a window.

good

This is a very thin Spline and it worked with a channel of 1/8 inch, nothing else. Recommend!

My cat destroyed screen mesh. This mesh replacement advertised as pet resistant. Replacement mesh more tricky to handle with installation as it is thicker than original mesh. However two years later mesh has stood up very well and appears “ immune “ to my cat’s best efforts. 😀