CTA Tools3759 Flywheel Mount Bolt Socket Set - BMW

It's a shame this is so expensive, but if you don't have it, you cant change the hubs on the my car.Feels like paying Ransome

It's exactly the tool you need for the job. Worked great!

This tool is necessary to access 4 rear wheel bearing torx head bolts. The tool length combined with a shaft slender enough to clear the abs tone ring gets it done. To allow additional clearance for manipulation of the tool, I removed the press-fit socket. The portion of the tool shaft which became exposed as a result of said socket removal is hexagonal and will accept common mechanical tools. If the repair is done with the vehicle, in this case a Ford Edge, 2009, elevated on a car lift, there is sufficient room with the socket in place. I did the repair on a garage floor, on a jack stand, which limited room for a #250....I.e. long.....torque wrench to “swing”. Removing the socket helped clear the coil springs. The torx head bolts had been in place since 2008/2009....10 years.....and I thought the slender shaft or torx “teeth” might twist or break when loosening the bolts.....there’s not a lot of contact area at male tool/female torx bolt interface and I thought the tool teeth might break. Nope. The bolts when new are torqued to 85 ft. lbs. Add 10 years of corrosion.....it took far more than 85ft.lbs. of force to break the bolts loose. The tool held up fine. I didn’t use an impact gun. I thought that might break the tool. I used muscle. Probably could have used an impact gun. The tool is of high quality.....good metallurgy. I recommend it. Dave Heitman, professional carpenter/contractor.........shade tree mechanic. Semper Fidelis

Can’t believe this is how Ford designed this hub assembly and blocked the studs with the abs gear. Didn’t want to risk grinding down a good T60 so I bought this. Did great but don’t forget the hub puller to push the axel back for more clearance for the bolts to thread out.

I am using it to change hubs on an AWD MKX, need it to access mounting bolts behind tone ring. Works perfectly. Putting tons of torque it with a breaker bar and it's standing up to the punishment.

I used the product to change a hub on a Lincoln saving me over 600 dollars.

This is one of those tolls that you have to spend a lot on and will most likely never use again. But I do like the build quality of the tool and it did a great job at removing and torquing the flywheel bolts. If you want to do the job you have to have the tools. But I always hate it when you have to purchase special tools like this one. I mean why couldn't they have just used a regular head or had it so you could get the bolt out with a shorter torque socket and an extension? That would have been nice. I gave this 5 stars because I think the build quality is excellent.

Would like to have a talk with the engineer that designed the way the Ford Edge hubs are installed... not impressed, but this tool makes it possible to get at the Torx bolts that you need to remove to get the hub out. Haven't had any problems with the tool, pretty simple, seat it properly in the torx head and everything should work.

A very useful tool and it did the job it was exactly intended for where a conventional torx bit wouldn't work. I applied 90 ft/lbs of torque and it held under pressure...it seems to be of good quality thus far! .. 😎

A must have tool for replacing the rear wheel bearings on a Ford Edge. Fits perfectly and saved me lots of time and frustration.

J'ai été obligé d'acheter cette outil pour changer les bering arrière sur un Ford edge 2009,s'en cette douille oublie ça faire la job

good