MCIGICM 10 Pair XT60H (XT60 Upgrade) Male Female Bullet Connectors Plugs

Good little connectors .. easy to solder .. strong. Fit perfect. 80 cents each roughly and worth every cent of it. They work fine.. shipped fast .. got to me within 12 hours .. they where easy enough to put on the wires that I made some trx to xt60 adaptors ..

Power plugs! No problems!

great for rewiring electrical bikes

good tolerances tight fit

I use these with some battery holders for 18650s. By grouping five in series and four sets of them together I was able to make a very powerful battery pack. They're hard to get apart and they have a gasket so that no water gets in and are very high quality. The part about being hard to get apart can be considered a good thing because they don't come loose from vibration but when you want to disconnect them you're going to have to have some good grip in your fingers or use pliers carefully to not damage the plastic and the gasket. Being able to use these with the heavy gauge wire requires good soldering skills and equipment. I accidentally destroyed one or two of them until I got the right soldering technique and a powerful soldering gun.

Great connectors just becaful with soldering , it can make the brass pins move in the connector. These has the end caps to help clean up the wiring and it looks great. My suggestion would to tin both the wire first and the end cup before soldering the wiring in there and watch your heat. Used these on a smart charger and use them on most of my door speakers for car audio .

These are what you use when you want something solid and professional. I soldered 14awg and 12awg wire to these with lead free solder, using 375C for 14awg wire and 400-410 for the 12awg (65W iron) to get it done - I'm not a pro at soldering - and these hold up to the heat. As most recommend when soldering the male ones, make sure to connect them to a female (actually just do this always) to help dissipate heat away from the plastic and prevent deformation. You'll also want a proper vice to hold them in place. I used the 'helping hands' alligator clip things, and it was a total pain. One thing is that XT60s can be crazy tight. Using needle nose pliers or some skinny tool you can squeeze the male pins a bit to make them a little smaller and loosen them up. If they end up too small they might not 'stick' together anymore in which case you can just open them up again to restore a stiffer connection. If its a connector you wont be disconnecting often, they're fine out of the box. Final comment. I separately bought an XT60 series harness and found that they were insanely tight when connecting to these XT60 connectors here. Even after compressing the male pins to make them smaller, and using pliers to squeeze the connectors together, I couldn't get them to seated fully. I ended up making my own series harness with the connectors here.

Ok

Leyendo comentarios decian que no eran genuino o que no entraban con otros XT60, pero pues lo probe en varios que tenia y si encajaban. Dice que aguanta 60A, pero no intentarlo que se achicharra, lo probe con 30A y no paso nada, pero pues si te recomiendan cable del 12, pues el cable cederia antes que el conector Tambien de que si se derrite, pues la verdad solde varios y en ningun momento se me derritio, y eso que le tardaba el cautin, pero tener cuidado, al final es plastico. Esta fuerte la unión, cuesta hasta para separarlos. :D

Been searching for these for ages. Just the ticket prompt delivery and very reasonable price. Highly appreciated and recommend seller.

Great..very happy

Muy buenos

reasonable delivery time and good quality.