MYJOR Kapton Tape 4 Rolls Pack (1/4", 1/2", 3/4", 1") - High Temp Polyimide Tape for PCB Soldering, 3D Printer Bed & CPU Protection - Heat Resistant up to 500°F, Strong Adhesion, Clean Peel No Residue

The kapton tape rolls was received exactly as described. The variety of sizes makes the roll very versatile, allowing it to be used for different types of projects. The quality meets expectations, and it provides excellent value for the price. Stick very well to the aluminum surface I was using it. Overall, it is a good investment and highly recommended.

This tape assortment came in handy when wiring a BMS to my Lithium battery pack.The thinner tape was for the individual wires and the widest for the wire bundles.It was a bit hard to get the tape started off the roll as it is thin but was able to use it fine once started.The quality is very good and the tape is strong. It's a great value for the price.

Not exactly identical to Kapton tape, both in a positive and negative attribute.Pros:- Price for performance is excellent value- Excellent resistance to extreme temperatures. Measured through infrared and direct measurement found that -film deformation began at 673 degrees and at 769 degrees, while the film appeared to burn, it appears that it isthe adhesive that carbonized as the film itself exhibited no perforations after being heated to nearly 800degrees. YMMV, but these are the temps I observed when testing heat resistance- Physical dimensions and thickness is similar if not more robust than Kapton film.- Comes on a rigid plastic spool identical to genuine Kapton, not cheap cardboard or similar cheap material making them tough enough to toss into a electronics tool bag without concernCons:The only complaint I would bring up is the relatively weak strength of the adhesive compared to brand name Kapton film and several similar products. This is not a deal killer as test adhesive will adequately hold in most applications as long as you clean the surface thoroughly before attempting to apply the film.

I use Kapton tape for protecting electronic components that I do not want to melt off of the circuit board when using my air desoldering station. This is just sticky enough to stay in place, seems to be the right film thickness (1 mil) and cuts like the mil-quality stuff.I have also used Kapton for a protective layer over loose radioactive materials when doing gamma ray spectroscopy. I had found that the old way of using scotch style tape would break down over a few years due to the constant radiation exposure. Kapton tape was intended for use on satellites and spacecraft so it is resistant to that type of deterioration. It blocks alpha particles but beta particles and gamma rays are barely attenuated.

Me ayudo mucho en mis manualidades de casa.

Good adhesive, works very well as you would expect. This is a good size, I prefer this and just cut it down to the size I need as I need it. I dont think it needs to be any thicker.

Worked well to help with SMB soldering

Same as description don’t test yet

Good

Making a microwave furnace. Perfect for my needs

Super merci

Good value for the amount of heat tape.

Received the package and quickly tested with soldering iron heated to 300C° The tape did not burn and/or melt. This is good quality and correctly advertised product. Thank you.