J-B Weld50132 PlasticWeld Quick-Setting Epoxy Syringe - Dries Translucent Yellow - 25 ml (Pack of 3)

Great stuff! I had a split in a 300 gal agricultural spray tank. Facing big bucks to replace the tank, I decided to take a gamble with this plastic weld epoxy. The spit was in 90 degree angled molded-in area. I drilled a hole at each end of the split to keep it from spreading. I then cut a vee in the split the length of the split. I drilled several holes about 3/16" apart the length of the split. I cleaned it several times with acetone and sanded it in between each cleaning. I cleaned the inside as best I could by spraying the split with brake cleaner several times. Then I mixed the epoxy as per directions and using rubber gloves, pressed the epoxy into the split so as to force it through and make a bulge on the inside. I allowed it to cure a couple of hours then applied 4 more coats, curing a couple of hours in between each coat. After it cured 24 hours, the epoxy remained somewhat flexible. I filled the tank to above the split with water and hooked it behind my tractor and drove up and down a rough gravel road at top speed for about 4 miles to see if it would leak. It is dry as a bone! I am thrilled with this product! It saved me a ton of money for a new tank and I highly recommend it! J-B Weld products have always proven themselves to me. I used plain J-B Weld to build up an axle housing that had elongated when a bearing went out. Can't say enough good things about J-B Weld products!

This stuffs makes plastic tougher than it was love it

This is my favorite epoxy for plastic repair. It's very sturdy.

This epoxy is quick setting and sets as a clear solid. It is easy to use, but must be mixed fully by the user prior to use. It is very important to mix thoroughly and to do so quickly or the epoxy does not set properly. Mixing is easy to do because one solution is yellow, and one can verify mixing visually without problems. One must be quick as this epoxy sets very quickly, and become semi-solid in about 5 minutes. Worked very well on plastic, nylon and even wood. It even worked competently on copper, but I don't recommend it for metal.

Worked great on repairing my sons rear bumper, thanks.

I did not receive a set of syringes--I got the blue clay that did not work as I needed it to, but I couldn't return it because of the urgency.Rough.

Shipped quickly and exactly the product that was described

Order description said dries off-white, yet the 3 received either says off-yellow or tan.

super für meine Restaurationsarbeiten an altem Spielzeug

did ok just waiting to see how long it lasts

Ok