Agratronix BHT-2 Advanced Baler-Mounted Hay Moisture Tester

works grate and easy install very nice to see what is going on all the way around the field

This is awesome. I sell small squares most of which go into barns. I have always been a little nervous about too much moisture in parts of a meadow and consequently starting a barn fire. No more! I am confident my product is safe.

Was exactly wat I need

Baler moisture sensors areeasy to install just make sure you split the wires on each side of the Baler so they’re long enough to reach the tractor.

It worked well for us. All we had before was a JD moisture tester that you stabbed into the bale. That gets old quick so we purchased the Agratronix tester. I calibrated it to the JD tester and set the offset to +5 and it’s been working well. I’m surprised at how well it catches wet spots in the bale. Wish we’d bought one sooner.

This product works great. I installed the contacts in my small square bailer with only 8 holes to be drilled. Then the signal wire was zip tied and ran to the tractor. Once the power wire was installed on the tractor, the display was mounted on magnets and stuck to the tractor fender. Once up and running it shows an updated moisture content every few seconds. It works great with no issues so far! I grabbed a harbor freight pelican knock off case to store the display in when not in use.

Works great

I liked how easy it was to install and to set up. Very little time to figure it out.

Nothing better than knowing what moisture the hay is on the go. Easy enough to install, easy to operate.