Recessed D-Ring 6,000 lb. Cap. Tiedown w/ Backing Plate - 6 pack

These are impressively strong and very nice that they drop out of the way. I have an 8' x 5' trailer with plywood deck these were installed on and the hardest part was finding stainless bolts etc, and an appropriately sized hole saw that didn't break the bank. I ended up using the backer plate as a template, marked the deck and used a saber saw. The backer plate was also great for drill guide for bolt holes!.Just be sure there's no interference with struts or wires under where you'd like to put these anchors, I thought of that just before making a big mistake, thankfully. The taller edge of the backer goes on the hinge side as pictured, and the loop goes in the direction of anticipated strap tension direction for best strength.There are weep holes in the ring wells to let water out! Nice touch.I haven't needed to trailer my bike yet, but have moved the riding lawnmower many many times over hundreds of miles (get yourself ratchet straps, buy once and be happy ever after) without problems. Some wood preservative (used up some Cuprinol) in the holes and cuts should help keep the deck from suffering the cuts.

I replaced six corroded ones that only had large washers on the underside. The rings were received as promised. They needed a tiny bit larger opening in my trailer floor, than the original ones, so I used a wood rasp to make the hole a bit larger. Not the fault of the D-ring and only added a few minutes to installation. The backing plate is outstanding. Very, very strong. My trailer has some existing screws in the floor that required me to get underneath and mark on the plate where they occured. Then drilled a hole in the plate to allow it to fit as needed. Some customization, but well worth the effort if you want the peace of mind when hauling your favorite 800lb bike in the mountains. The units accept carriage bolts. You will need to get them from your hardware store with length as required for your floor. Highly recommend these D-Rings. Well made and heavy duty. Excellent product.

Installed easily in my enclosed trailer. Very durable, no issues after an entire summer of use.

Do yourself a favor and buy the three and a half inch hole saw. It was super easy once I went back to the store to buy that size. I installed two in the front, two in the rear, and two directly over the tandem axles.

Installed 10 in a enclosed and overall very happy with them.

Great product and easy to install with the back plate to be used as template for the anchor.I installed six of these on my harbor freight trailer and will never have to worry about anything I carry not be able to hold with these monster recessed D-Ring 6,000 lb tiedown anchors.The SQUARE HOLES on the anchor are way better to use than the round hole anchors which look similar.The square holes make installing carriage bolts an easy one man/woman job. Thanks for a great product!!!

Installed six on Triton utility trailer. Quick install, really, even with holes to cut out. Pretty much flush to the bed and quite strong.

Nice tie downs I installed 6 of these in about an hour I was very sick at the time as well did have to buy a good hole saw