F-Type Coax Cap Cover, 5 Pack 75 Ohm Coaxial Terminator for Unused Coax Jacks, Splitters, Amplifier, Coaxial Cables, TV Antennas, Wall Plates, Boosters, Home Theater Wiring, Stop Signal Leakage

These Coax Caps fit my need perfectly. Needed to terminate some cable TV cables after moving to streaming-only. These caps are manufactured very well and easily attached to cable TV wall connectors and coax adapters to terminate cable TV coax. Each cap is identical to the others...no defects...perfect. No worries here and a great value for a specific need. These caps arrived next day. Excellent!

Works great, I don’t use cable TV but have cable internet and the house had 3 open coax plugs. Installation is as easy, it’s just a cap with resistance. I don’t have concrete proof but from speed testing and quality benchmarks these helped stabilize my internet speeds. It is a cheap install that doesn’t hurt at the worst in my opinion 😅

Good product. I used the caps on my open ports on a splitter and i could see ping differences in different programs. They work plain and simple. 10/10

These are good to cap the open ended connections in your home, to prevent signal leaks. Terminating the open ends keep the signal strong for the ends that connects to your cable box. This also prevents any interference from going in one end, affecting your overall signal.

I purchased these terminators for use with a television over the air antenna combiner. These are mechanical, have no electronics, and no moving parts. The serve one function, which is to terminate cable connections in order to prevent signal loss or interference. They are well made: sturdy metal, properly machined threads, stiff conductor wire, smooth and evenly plated surfaces. I needed them because I swap between one and four indoor antennas on and off the combiner, which leaves up to three ports open at a time. I haven't seen a big difference between using them and not using them, but I can see the difference. Every improvement on a television picture. Using them is easy: Line up the stiff wire conductor inside the terminal with the hole in the center of the insulator in the port. Be sure to line them up straight. Push the terminator toward the port, inserting the wire, until the terminator just touches the port. Then thread on until tight. I'm going to order some push-on type connectors to attach to these terminators so that I can just push on and pull off when changing antennas. That would make these perfect. I didn't rate the "waterproof" because I use these inside only. Also, these are a great bargain at the price. Buy them for a better view (and better stereo, too).

Does the job

Product was perfect. Make sure and mix in with other orders cause deliver cost more than item.

I installed an antenna with a 3 way BAMF splitter with only two tvs connected to the splitter. Leaving one open. I couldn’t get a channel to come in without pixelating. I read up on Reflection when there’s an unused opening on the splitter. I installed this little gem and as able to pull in a channel that others in my area (on Reddit) were having issues with.

The termination caps are working good!

Worked well. Easy to use. Saved me a lot of money

Just what I was looking for.

Work great. No signal leakage

Just what I needed, no problems.