REM 46634-8 lb. Pail

Works great for mounting HMMWV tires. Very thick so use a firm sponge or applicator.

I used this mounting compound when I worked at a Sears auto center in the 70's. It was a must for tires that had been laying flat for a long period of time & the tire beads would not reach both sides of the wheel. It worked when other "tricks" to seat the tire would not. Reusable & well worth the cost.

I seriously had doubts! Wow, It's some kinda magic crap, it's awesome.

I do my own tire mounting and dismounting on old cars, often putting used tires on less-than-pristine rims. Getting the beads to seal is often a challenge. I did three 14" tires this week using Murphy's Soap for the first time. The stuff is a bit sloppy and involves a short learning curve, but once I accepted getting messy I was able to get the beads to pop more easily than when I've used ropes, straps, dish soap, foam tubes, etc. The goop squeezed out as the beads set, and so I could scoop it off the tire and use it again. Overall, it made a frustrating job much less challenging. I'm happy with the purchase. UPDATE: I used it on a fourth tire, and it worked just as I described above. Work the goop in between the tire and rim, hit with 100 psi of air, and POP! The beads are seated. Then scoop off the squeezed-out goop for reuse. After doing four tires, I haven't used up more than maybe 10 percent of the 8-pound bucket. I've fought airing up tires for decades, and this is by far the best way to suceed with the fewest cuss words.

This product works wonders. Mounting and dismounting semi tires is a breeze with this. Plus it seals the bead without using a bead blaster most of the time using this product

Dilute it with water and use a small brush to apply liberally. Then wipe clean. I have just started using this on a rear dirt bike tire I dismounted and remounted to flip the knobby tread.It made the job so easy! And cleans up very easily with a clean rag. I also used it to wipe down and clean up the tire and rim and rim tape. It did a great job. Everyone is using this stuff at full strength, Just gooping it on, and wasting it. Dilute it with water and use a small brush to apply liberally. Then wipe clean. I threw away the other mounting paste I had , which was glycol based( made in china.)

I was changing tires using only dishsoap and at times window cleaner. I tried this and it was more slippery and made changing tires even easier. I have my technique down for motorcycle tires and i would say this product (large tub is nice) works as intended and i can see why motorcycle shops use this type instead of just dishsoap.

I have used this to take off and mount new tires, it works far better then soapy water, would buy this product again for sure!