PN00218-CYT14 Cytron Motor Driver 30Amp 7V-35V DC 2 Channels SmartDriveDou MDDS30

I grabbed one of these to power the drive motors in an old electric wheelchair. The goal was to convert it to a modular utility platform. This little controller drives the wheelchair motors quite efficiently. When pairing it with a receiver, I did have to dial in a ton of expo to make the acceleration curve smooth, but that could be to some degree, because of the way the motors were wound. Since they were built for torque, they tend to start more aggressively. Overall, this controller excels in the application I'm using it for, and I'm happy with the outcome. I would highly recommend it if you need a decent, affordable brushed motor controller.

I purchased this motor controller to replace a burnt Sabertooth controller that I was using for an R/C lawnmower build. The board is sturdy and seems well built. It stays much cooler than the Sabertooth but has less features. It's also about $40 less than a comparable Sabertooth. For my needs, this board is a great fit. Not much to mess with after installation, 2 channels (one for each motor if using for a similar project) can be used with tank style controls or mixed at the TX to get different configurations. It was very simple to do a basic R/C set up. Just connect to motors, power source, plug in RX, set DIPs and you're good. I'm certainly not an expert in this area, but in my opinion this is a very good mid / high amperage motor controller that is built to last.

Very nice motor controller. I had one issue that I'm unable to solve. The documentation makes reference to newer boards having different firmware and those boards being labeled with a green sticker. The version change is at v1.10. I see v1.3 referenced on the board.. however I don't know if that's higher or lower. Does it really mean v1.30? The only reason I would assume that is because the v1.10 update was several years ago and the likelihood of these being old stock seems unlikely.

I must preface my comment with I used the controller for a unique project. I used the motor driver for a DIY powered golf trolley. I use the hot RCDS 600 remote. be very careful of when wiring the motor driver make sure you’ve got positive negative correct or it will burn up the unit. Also , never push the cart without the battery on. Even then, it can only be a very short distance I wasn’t aware that this would damage the motor driver until I research it on AI I improvised and can plug and unplug my motors. I’ve used it twice and it works great. Just gotta be real careful not to push without the battery on. (The motors act as generators)Also, for my application I had to mount in waterproof box

Works as expected and just what I needed and cheaper than other DC motor controllers.

Es de lo mejor

This was so simple compared to using an arduino.... with a pwm motor driver with pots and rocker switches the route to pins-in and out. Literally ran my, rather large, 200lbs rc robot with my tx and rx connected. I did try and change the tx setting while it was live and it ran away.... but that was my rookie mistake. I would buy 3 more if they were a little cheaper. But WELL WORTH THE MONEY

Works perfectly with wheel chair motors.