Turn Signal Lever Extender Car Styling Adjustment Steering Wheel Signal Rod Extension Turn Signal Lever Position Kit Aluminium (Black)

I'm very satisfied with the product. It's definitely a lot easier to signal. I'd say if u have a deep dish aftermarket steering wheel and actually use your turn signal this would be a great product for u. I used only the first pair of 3M pads. I could probably use my second pair to make it fit a lot better. I also used some adjustable wrench type tool to fasten the bolts more. Really easy install. Not sure if I'm going to paint it red or not.(This fit my 2008 Kia Rio)

no matter how you tighten it or use the foam pads, the arm still fits loose and will rotate. Also, it makes the turn signal stalk heavy that it won't rebound 100% of the time on left signals (down).

Must have for people running a deep dish steering wheel. If you can’t get it tight enough with the foam shims it comes with your turn signal arm is very thin, or you don’t have the right tools. I installed mine on my Scion FRS and have never had it get lose. It’s been on the car 4 months.

I like the look! I have had it for more than a few months so far no problems. Works well an functions properly. For install I recommend to adhere the sticky foam to the blink arm first then bolt the extension on for a secure fit.

works good with my aftermarket steering wheel, my deep dish makes it hard to reach the blinker but this helps. just don't over tighten the screws like I did and you'll be fine

The hardware it came with was wayyy too short to fit around the turn signal stock in my car. As a result I needed longer bolts so I had to make the hole bigger with a drill just to be able to fit bigger bolts. Fixing and fitting it took me about an hour. I know it was only 10 bucks, but somehow I expected...more?

It did not work with my vehicle it would slide off

This is a good product.