Everbuild 2-Part High Performance Wood Filler – Fast Drying – Weatherproof – Easy to Mix and Apply – White – 1.4kg

Great 2 part filler. Decent price for this quantity. As ever with 2 part filler only mix small amounts, say golf-ball sized. It sets off very quickly, 15 minutes.

Good stuff., inside or out. Will buy again. With wood it seems a good idea to treat soft wood with 'wet rot wood hardener' before applying epoxy wood filler which will really anchor it in position, and put a few brass screws, left a little proud so it will never come loose. Repair to a window sill. Possibly a little stiffer than another make, but perhaps better value. Rub down a coat of paint, not visible, and wont give any trouble, not there anyway.

Nice amount of filler included in the tin, together with hardener, which you have to mix together to fill wood, after applying wood hardener and allowing it to dry. The filler sets within approximately half an hour and does the job, setting to a hard finish. However, the only drawback is that it is quite sticky when you try to fill any holes in wood so a bit difficult to get a truly smooth finish. You can sand it before it sets too hard and try to smooth it out. It does the job and a lot cheaper than buying a new window or door. I`ve used the mahogany finish in the past and it is totally waterproof and lasts for years. Good price too.

I have a fair amount of using these types of polyester type fillers and found this one OK to use once you got used to it. It felt slightly 'dry' though when smoothing out compared to some other makes and went off very quickly, even when using a very little hardener under cool conditions - which I was expecting. Overall though it worked well and I would buy again.

This stuff is great use it often and bulk buy when I can and when it's on offer. I use this this to fill hinge apertures when fitting new doors and the old hinges have been oversized. Fills them in one swoop. Minimal sanding effort can be chiselled ( with care )

Does the job.

Followed the instructions to the letter and honestly, within 5 minutes the product was unusable because it had set. I know it’s summer, but it’s 8am in the morning so not hot. I’ve completed filling in screw holes of about one square metre of floorboards in a bedroom before it had set. Honestly, get some other product or call in Houdini to do it and save your organs.

I use it for large areas of wet rotten wood on outdoor windows. First cut back to the dry wood. Then use hardener. Then use this. Worth using golf ball sized pieces and adding small pea sixed hardener from tube. I worried about running out of the hardener but just enough. Use a putty knife or similar to extract from tin. Squeeze hardener from tube. Use a separate knife to mix well for a minute or so. Use clean surface to mix on. Do not use mixer knife to extract from tin. Spread into gap with mixer knife within 5 minutes. Smooth down with one stroke of plastic. clean off mixer knife and mixer surface and plastic smoother. Start mixing again...It works. It smells bad and I am happier using outdoors!