Custom Dynamics LPF-HRZ-B-LP License Plate Frame (Flat-Style Black )

This is a very basic designed frame that works with almost anything. Install is simple and straight forward. My only complaint would be the bolts holes in the frame and the bolts that come with the frame are kind of thin and the bolts are a little longer than they need to be. I had to cut two of the four to make them work with my application. Other than that it is a good product for the money.

Absolutely does not light plate with raised letters/numbers. Throws light to ground so I think if the lights were further out over the plate it'd be perfect. Keeping it. Figure if a cop is behind me his lights will light my plate. Looks good. Easy install. Flat black screws for plate attachment was a good inclusion. 2 stars bc of lighting issue, but I'd still recommend. Refer to this post in court. :-). Also, had to cut my Ohio plate all the way across the bottom to make it fit flush. Could have been a bad plate but suspect frame is a little to small for a standard plate. Also had to cut notch for wire. Yeah, two stars, but keeping it.

With just a little bit of "know-how" you can install this plate frame super easily. There's no easy bib connectors for this product, but it was easy to wire into my harness all the same. I have a 2011 Triumph Daytona 675 (with a two-bros fender eliminator kit that came with the exhaust) for all the bros out there wondering if it fits. It's honestly way better than the factory lights.

Leds are very dim, but it’s sharp and I like it, not like I want my plate to be seen anyways 😎

This frame looks good and cleans up the rear of the bike nicely. I did have to trim my plate with tin snips to get enough clearance for the wire. That could have been routed better. The light output is adequate, though with raised letter plates like we have here in Illinois it casts a lot of shadows. The bottom of the plate is pretty much left in the dark.The light output is greater than the two license plate bolt lights I used previously, but neither are anywhere near as bright as a conventional bulb. I considered mounting two license plate lights at the bottom facing up as this would probably even out the lighting, but that would also ruin the slick look of the matching flush-mount bolts provided. In all, it took a lot of fiddling to get installed correctly, but once mounted you'll never take it off and it looks good. Since you've butchered your plate in the process, there's no going back anyway.The light bar at the top is low profile and at a glance you'd never know it was an illuminated plate frame. I would purchase this again, though it's not as simple as bolting it on and hitting the road.

great license plate mount for 2014 teryx4. Works great to mount on the rear brace. Easily tapped into rear light wires. Just had to notch the plate cover with a pair snips to allow the cord to not be pinched by the back of the mount. Looks and works great!

Great product , DURABLE , fast shipping A+++

Paint job didn’t hold up well ... started fading and chipping in just a few Months

bien