Saxton TCT Circular Wood Mitre Saw Blades 255mm x 40 & 80T x 25.4mm Bore fits Evolution Rage Saws (Pack of 2)

Perfect blades for the job, perfect fit and definitely value for money.

My trusty and very old 40t 10" TCT saw had many chipped teeth so I decided a new one was required. It cost about £40 new so I was expecting about £80 to replace. To my amazement I found that less than £20 was not unusual. So I decided to buy both 40 and 80 tooth versions. Both blades run accurately and cut very smoothly. I'd say the side cut isn't quite as smooth as the old one when it was new/sharpened but still pretty good. Both blades have holes that can be used to hold the blade when loosening or tightening the spindle nut. The only negative was Amazon's speed of dispatch! I didn't check my bench saw but remembered it was 1". Well the nut was but the spindle was 5/8". I tried to cancel the order within a couple of hours but was told it had already been dispatched. However they told me to refuse delivery. When I looked for a similar deal for 5/8" bore blades there wasn't one, so I decided to keep the blades and made a 1" to 5/8" reducer (I have a big metal lathe).

I used the 40 tooth blade to cut through 4x8 buttons. Went through like a hot knife through butter.

These were purchased to replace the blade that came with the Evolution table saw so far clean cuts

Great quality product and very good price.

Only tried 1 of the blades at the moment. However, it's cut through some 40 mil thick Oak without a problem. Very impressed. Miles better than the original evolution blade, which by its nature is multimaterial anyway.

Fits tightly on the Evolution 255tbl+ . Have only used the 40 tooth blade so far but it cuts well.

Very surprised with the quality, cut very well and last as well, will definitely be buying saxton products again, much cheaper than other brands.

Ottima lama rapporto qualità prezzo

Matériels conformes à l’annonce et de très bonne facture

Super Set und Preiswert- leider sind mir die Original Evolution zu teuer...

Font le job ! coupe très bien mais on tendance à bloquer dans les grande épaisseur.

Avevo visto la recensione di queste lame per evolution 5s, e drvo dire che sono ottime soprattutto quella da 80 denti allego foto su diversi materiali, il taglio di sinistra e sempre la saxton quello di destra con lama originale, (taglio visto sempre in uscita)la prima è su multistrato 8mm,la differenza non è molta ma si mota un buon miglioramento, la seconda su massello di castagno 20mm a troncare, anche quà un'attimo risultato,la terza su pannello di abete 18mm e anche quà un'attima differenza rispetto quella di serie, l'ultima è un taglio lungo vena e anche questoottimo(solo con saxton) X l'evolution la consiglio per lavore sul legno!