Universal Lighting Technologies B260IUNVHP000I Electronic Ballast, Fluorescent, T12, 2-Lamp, 120-277V

I had to replace 3 old standard ballasts (806-BR-TC-P) in some 8' fixtures in my garage and I elected to go with the newer electronic version. These worked great ! They came with instructions but they were not really needed. The schematic on the unit is all you need. I cut the wires of the old ballast near the ballast itself and remove it with one speed nut, then I put the new one on using the same nut since the length of the new and old ballast is the same. I then cut the old wire so they were about 10" long and made sure that one set of tombstones were independently wired and the other side tombstones were shorted together. I used wire nuts to attach the new wires to the old, put the covers back on and installed the bulbs. Pretty simple. Note: You may need some extra wire nuts to do the job.

I don't know if it's just me but the ballast seem like it was used then reboxed. I may be wrong but that's my honest opinion

Worked great! Great replacement!

I replaced the fixture, what am I going to do with this?

I'm sure it's perfectly fine, but it was the wrong voltage for me