Ammo by Mig 40ml Ultra Glue for Etch, Clear Parts & More # MIG-2031

If you are building scale models (especially airplanes) and always fear fogging on canopies and transparent parts this is your solution. Dries fully clear in a few hours, applied easily by brush or toothpick. Great product overall.

I've been looking for an alternative to CA for a while now as I can't use it without a full face respirator or risk a nasty 48 hour allergic reaction that keeps me in bed! I've tried White glue, varnish and even double sided sticky tape with varying results. When I received this and saw what resembles white PVA glue I wasn't hopeful, but used it anyway on a Trumpeter type 23 build with aftermarket PE. It is quite thick and I am probably putting a little too much on but it does stick after a while. It's not instantaneous so some steady hands required to hold in place. The proof in the pudding came when I had what could have been a major disaster. Whilst repositioning my magnified angle poise lamp, it slipped and crashed down on a nearly complete bridge section sending it to the floor. Expecting to find a mangled mess and a load of PE lost to the carpet monster, all was still attached. I find CA bonds very brittle so bits get knocked off easily but this stuff seems to be slightly flexible. Some of the PE was bent badly, but the bond held whilst I did some pretty major bending back to shape. Very impressed. Excellent! Give it a try.

As above so ensure you clean any excess straight away.

Unable to comment first hand as I’m yet to use the product. However Ammo Mig have a good reputation within the hobby industry.

Good stuff

Is my new goto for gluing PE or clear parts

Good quality glues well

I bought this to use on PE parts of warship model.It was easy to apply but it didn’t stick.So it was back to Gorilla for me Update Anyway my gorilla ran out and I needed some super glue for a couple of repair jos and It worked just fine. Easy to apply and fairly quick to set

This is really great modeling glue. Much stronger than most acrylic glue and when dried, and clear coated, is invisible. I use it to attach brass railings or other small brass pieces to 1/700 scale ship models and when dry, it is almost impossible to remove the glued-on part. Would be great for attaching canopies and windshields on car models since it doesn't craze the plastic and any that runs out of the seam can be easily removed with a drop of water on a paint brush and touching it with a tissue which soaks it right up. They say no residue and they are right.

Goede lijm voor photo etsch en doorzichtige plastic delen

Conforme aux attentes

This glue is absolutely perfect for photo etch. I can't attest to how long it lasts, but it does form a very strong bond between styene and photo etch parts while building a model. It usually takes me a month to complete a model and the parts I glued with this item are still bonded strong as I'm writing this review. I 100% recommend this product!!!

Ne me convient