Case Club 4 Revolver & Accessory Pre-Cut Waterproof Case with Silica Gel to Help Prevent Gun Rust

If you've ever owned a Pelican Case, then you'll be just as satisfied with this case by Case Club. It has heavy duty construction and I'm sure it can take a beating as good as the other guys' cases. The pre-cut foam inserts are a huge plus, since you don't have to take the time to exacto-knife your guns' shapes yourself, or even pull-and-pluck, which can also be a pain. The way they have these pre-cut would be next to impossible to do yourself, and they hold my revolvers nice and snug. The only down-side is that there is not much "extra" storage space. The pictures show the space to the left with a shallow side and a deeper side, but mine did NOT have the deeper side pre-cut. I think I can cut it myself, but that kinda defeats the purpose! I'll probably just leave it alone so I don't accidentally cut into the hollow space below it, which is where the longer barreled guns fit. Besides, I'm using this primarily as storage, not for transport. Other than that, it's a great case at a great price! I will definitely purchase from Case Club again when the need arises.

I have only used this for transport to and from the range and at some rural property. It works very well. It has been in the rain for a minute or two, but that's about it for harsh conditions.It holds four pistols and/or revolvers, along with a goodly number of magazines in a smallish compartment. It feels well made and I appreciate it having room for more than one padlock. I like that I can lock this to the frame of the seat in my truck using some chain and an extra padlock, so if I run in for breakfast along the way, I am confident it isnt going anywhere.While I can't comment on how it would resist the elements over an extended time or very harsh treatment, it feels sturdy enough where it could bounce around in the back of a truck with no worries. The contents are snug in their slots, so they would be just fine.

I have purchased another model earlier and was made very sturdy. I could not be any happier. I do recommend this brand.

I needed a gun case for my revolvers. This fit the bill perfectly. On the 3rd attempt they got it right. No worries for quality, this case is great. Problem with my purchase history is 1st shipment had the top layer glued in backwards. Lower layer cut outs didn't line up. I sent it back for replacement. The 2nd shipment arrived with the plastic case only and no foam insert whatsoever. Return it for refund (no option to replace it again). Placed another order and Bingo! Finally got it right..QA is lacking, but not the case.

Outstanding design & quality. The inside bottom foam is what appears to be one piece. But upon closer examination, you will find that it is pre-cut to allow pieces to be removed for a custom fit. I at first thought my new Ruger Mark IV would not fit, then realized that one or more blocks could be removed under the grip so it fits lower in the case. And a closer look at the recessed area on the left revealed more pieces could be removed for storage of magazines, etc. When you remove pieces, absolutely don't discard them. They may be used in the future to custom fit an auxiliary piece like a revolver cylinder in one of the unused pistol positions. Only complaint I do have is an illustration sheet wasn't included to show all the pieces which could be removed to allow customization.

My husband loved this case! Very heavy duty

This holds my Colt Army Model 1903, Colt Army Model 1909, Colt Army Model 1917, and S&W Army Model 1917 perfectly. The little storage area works great for holding a ziplock bag with my half-moon clips and my clip unloading tool.

Great case, did not have any issues with foam being glued in incorrectly, like other reviews have stated. Arrived in perfect condition and after removing the required inserts, revolvers fit great. Using it to hold my cap and ball revolvers.