2 inch Leveling Lift Kit Compatible with 2005-2023 Tacoma 2003-2023 4Runner, Leveling Lift Kit Fit for 2005-2023 Tacoma/2003-2023 4Runner Front Strut Spacers Raise the Front of your Pickup by 2"

I have a 2012 Tacoma, and want to level it after I upgrade my front struts to 2.75 inch difference in front to rear now.I purchased the 2.00 inch lift blocks and proceeded to install them., and the instructions are also helpful. I Jack up the rear and supported it with Jack stands on both sides and left the Jack under the differential on my truck,removed both tires.Next I removed the bottom of the rear shock and then the nuts that held on the u bolts on one side and with a second jack under the axle tube, after the bottom plate was removed I lowered the two jacks and let the springs relax until there was a wide enough gap for the 2.00 inch block to fit between the spring and the axle tube plate. Also it took a bit to get the pin and the hole in this block to line back up on the axle. Once this was done, I raised the axle tube back up and added the new u bolts along with the u bolt plate to the bottom of the axle and put all four washers and nuts back on and tighten. It also helped to remove the 12mm screw that holds the emergency brake cable on to get a bit more slack in the cable when lining it back up with the axle top hole and bottom pin . Make sure you put the smaller end of the tapper in the block facing forward per the instructions. Then I just repeated the same thing on the other side of the truck, and it took around 3 hours to install, also two people are helpful when doing this installation. Now my truck has a nice level stance. I have a few pictures I took after the installation too.2.00 inch blocks u bolts,washers and nuts are all quality components and worked well. I hope this helps you.

Everything fit as it should , Looks great!!

Easy to install lifted my truck higher then expected, definitely happy with the results

East to fit but I would take it to a mechanic next time.

I’m happy with the results at first i was expecting it to look good on my 2020 Toyota Tacoma. Fit meant and everything was easy.

The leveling spacers were good quality. Only downside is there was no instructions in the packaging. However, there is plenty of YouTube videos to help you install.

I wanted to make the rake pick back up. Someone installed the front shock spacers but nothing on the back so my truck rode horrible, bouncy, put my an arms in a bind, and the truck floated all over the road. And don’t even try to even put a trailer on the hitch. Bought these and now my rear rake is slightly higher than the front but bc I tow a dual axle bass boat it’s much needed!!!! Make sure to buy the wedge/angled blocks bc that’s how your axle is made and if you don’t then you will have bad vibrations.

After having my front end only 2001 Tacoma TRD, the rear of the truck was lower, this solved the problem and couldn’t be happier

La calidad del material del producto más que perfecta, está instalado en mi vehículo y hasta la fecha sin problema, además de la terminación de las piezas muy estéticas en comparación con otras “hechizas “

No batalle nada...

Queda muy bien y da un espacio de altura muy bien