Lid Stay Hinge Soft Close Safety Lid Support Toy Box Hinge for Kitchen Cabinet of Top-Upward Opening Top Flap Doors

Hey guys it's very easy to install it comes with a template even though it's in another language you follow directions and put it in the Box the way it shows you put it on the side it touches the top the paper does the paper touches the back but it says left and right hand but you have to take the where it says left hand and put the paper upside down you'll see how it works is very easy Once you figure it out

We have been using a one of these soft close hinges on a solid pine toy chest with a 18" by 32" top and it has performed like a champ for over a year.

I have a hamper in my bedroom that also works as a bench. The lid was clumsy and heavy. When closing the lid it would slam shut. This device works well and keeps the lid open and with a gentle push, the lid closes slowly. The only problem is that after a few years the device broke. I purchased a new one because I couldn't live without it.

RUYUFE Toy Box Soft Close Lid Support 70N-120NAfter two attempts with other devices, these are actually soft closing. The gas shock type required mounting lower on the sides than was possible on these window seats. The metal adjustable type (QBOSO) were not really soft closing. After closing slowly for about 45 degrees, the lid slammed shut. These are better suited to a downward opening lid. It would be soft opening in this case.I installed one of the Ruyufe lid supports on each of two 13.5” x 52 3/4” window seat lids. The lids have two flush mounted hinges and weigh 10-12 lbs. each. I added blocks to the sides to extend the mounting surfaces. After attaching the top bracket as recommended in the instructions at 6 inches from the back edge, the lid only opened to about 75 degrees. Moving this bracket down 3/4” allowed the lid to open to 90 degrees. This resulted in the screw closest to the hinge to be centered 5 1/4” from the hinge side of the lid.The Ruyufe lid supports allow a secure opening to 90 degrees with the installation modification explained above. Pull the lid down 5-10 degrees, it closed very gently all the way down.I didn’t expect it to be so difficult to find a device that would enable soft closing for my situation. A toy box with solid sides would allow the gas shock type to work. A downward opening lid would probably allow the QBOSO type to work as a soft opening device. With a couple of modifications, the Ruyufe lid supports were the only type to work for my window seat lids.

There is no Way my grandkids will get their fingers pinched in the toy chest now. Very slow action and the mechanism is made so that they can’t get their fingers in it.

I built a wood outdoor storage box. The lid is approximately 30 lbs, so I installed two of these hinges on the lid (right and left side). It does not “soft close” as much as I hoped so strength of hinge is not up-to-the-task.

Product title is an outright lie. And they thought, what? We would just but another because the combined weight might be enough? Verify your products before you sell them to customers. This one did NOT hold the lid off my kids toy chest.

The media could not be loaded. Oct. 12, 2022: RUYUFE's Lid Support Hinge was easy to install. It took me less than 10 minutes to install it onto my parcel box. It has a very easy template that you can use. You don't need to use any of the included measurements, but you can if you want to. My lid is very small & light weight, so it doesn't really need the full 120N support of the hinge. It goes down very slowly; it will stay open; you can push it down to close, as well (it is stiff going down, which is good for me). It stays open up to 90°, and it was the right price. The materials are a sturdy and solid metal construction. Thank you, have a nice day. PaulJC 10/12/2022