Eaton GBK1020 Ground Bar Kit Used with BR and CH Series Loadcenters

I used this grounding bar to facilitate relocating grounding wires that were congested at the neutral bar on a vintage Bryant main panel and to use the lug on the bar to attach a #3 AWG grounding wire for a new 125 amp subpanel. Had to drill and tap two 10-32 holes at the main panel to install the grounding bar. I used an inexpensive 10-32 tap available at amazon.

Works ok with Siemens 125a sub panels, you're going to have to figure out how to mount them, hardware is not included. I just used a drill and self tapping screws

Product was exactly what I ordered and has been working in my circuit panel for a year.

Fits Eaton br boxes

Definitely recommend exactly as described in description… Solid product

GOOD: It worked with the gauged wire I was using. BAD: Had to drill retainer screws to hold it in the sub-panel and did not supply the self tapping screws to do this.

I have a new Eaton BR main breaker panel that did not come with a ground bar but it does come with drilled and tapped holes to install one on either side. The holes in this Eaton ground bar do not line up ... they are about 1/4 inch off so I had to drill a new hole in the panel to get this to fit.

https://www.amazon.com/dp/B0002YWUAW?psc=1&ref=ppx_yo2ov_dt_b_product_details I bought a Eaton BR panel and it had no place for this ground block. The block was functional and the shipping was fast however I expected the block to fit in the sub-panel without modification to panel and I was disappointed,