Anbull 1250W Electric Hydraulic Rebar Cutter, Cutting up to 3/4 Inch 4-20mm #6 Rebar, with Replaceable Jaw Blades, Cutting Speed 3-3.5S (1250W RC-20)

I am in the Cold Heading business and this product replaces very expensive and problomatic manual cutters. It cuts through our CHQ wire with ease. We put it on a roller table so get it around the shop easily. Customer service was also extremely helpful since our first order was damaged in shipment. They replaced in 2 days and made sure we were happy with our purchase. Would recommend.

We've been using this on the job site for about a year. We normally set it up on a 4x8 workbench, but it is possible to cut rebar 'in place' if you have the room. It's just an armful to hang on to. We cut #3-#5 Grade 60 rebar with it and am still on the first set of blades. We did have a problem with it taking a lot of trigger clicks and time to make a cut after about 11 months of use. The seller helped us with some ideas. What worked was to hold the trigger on for over 60 seconds while not cutting any rebar. Not sure exactly what that did, but my guess was it somehow bled out air from the hydraulics allowing it to function normally. In all we're happy with it and glad we bought it. Sure beats cutting rebar with torches, grinders., or cut-off saws; or for that fact manually!

Just did a lot of #4 and #5 rebar. Works great. If the hydraulics seem slow just loosen the top fill plug to purge some air.

Set up in our shop next to the rebar bender. The men like it so much for cutting rebar they now cut the bar in the shop rather than in the field. I like it because it is safer and faster in the shop. Well worth the money.

These are junk I purchased two and they replaced one that was bad but they will start pouring fluid. You can keep them working by constantly adding fluid.

Cutting #6 rebar

Good product. Great price

I have not used it yet but im sure itll do the job...