iJDMTOYSmoked Lens 27-SMD Amber Full LED Front Bumper Side Marker Light Kit Compatible With 2010-15 Chevy Camaro Replace OEM Front Amber Sidemarkers

Quality

Fits perfectly. Passenger light had to be assembled a with a slight alteration due to the light assembly slots being incorrect, but was able to be fixed with a slight bit of filling to the plastic. Looks excellent compared to the factory amber lighting! Highly recommended even with the slight mod.

They were very easy to install they felt like a high quality product, definitely recommend for the price!

The install wasn't so bad. I had to change to my winter wheels & tires so I took the opportunity to also install the sidemarkers. It only takes three (maybe four) torx screws and a 10mm (i think) bolt to install the sidemarker. The side of the rear bumper pops right out once you remove the aforementioned screws and bolts. Install is easy. Make sure the metal prongs( (i don't know what they're called) are flat on the connector.

These were shipped fast and look great. I only wish they were shipped with some instruction tips. YouTube helped a little, but everyone seems to skip the parts they think everyone knows. So here are those missing bits, just in case you're like me:1) When removing the old marker light, jamb a regular screwdriver into the little hole behind the marker. I found it best to use a flashlight to help. The videos show this but don't explain that you're trying to make contact with the plastic latch without prying; you're just trying to push the end so it releases. Don't pry! Imagine a lowercase "n" with one end attached to the marker and the other open. You're trying to push the end that isn't attached, which is closest to you, to release it from the bracket. Once you do it a couple of times, you can do it in about 2 seconds, though you'll probably never need to do it again except for the other side. It's easy, just not the first time.2) You don't have to disconnect the stock wire connector - just gently twist and pull it out of the marker light. The connector end of the JDM wire end gets inserted where the glass bulb is that you removed.3) Although it will work without doing this, be sure to twist the part that had the bulb in it back onto the marker. This will help keep water and dust out of the marker electronics. It should only go on one way.I hope this saves you a little time. It's a good product!