Supplying Demand WB35X29720 WB35X29721 WB32K3 Range Stove Oven Door 54 Inch 16 Clip Gasket Replacement Model Specific Not Universal

- used needle nose pliers to pull out the old prongs- pre-measure your length needed, I came up with 53-55" depending where you lay the tape, so this 54" seemed like it would fit & did, this is 54" with 16 prongs, fit my apt's Hotpoint stove oven door perfect (model RB525DH1WW), it doesn't go all the way around & isn't supposed to, cause hot air rises I guess so the bottom border is left without the rubber gasket seal.- there were more holes in the oven door (22 exactly), only 16 were used on the previous seal that was there, same with this one, the alignment of the holes/prongs was perfect.- Even though I couldn't find my oven's model# on the product descriptions' list at the bottom of product page, this generic replacement part worked perfect & i think the quality of the rubber is fine, same as what was on there before this one. Manufacturer's website had it for $40-50- installing: be careful when putting prongs in, when you check if its "in" or not, dont pull too hard on the rubber to look underneath or prong could rip out i read on a review. See my pic you can see the old prongs I pulled out. They have a "flat T-head" kinda that you can feel inside the rubber, gently align it perpendicular to oven door (straight up/right angle), feel the T-head with thumb, gently press prong in

oven door gasket est arrivé assez vite et a parfaitement matcher avec mon four

Works for my oven

I use the 54 Inch 16 clip Have to make some new hole in the robber but, it did the job.My stove is a White-Westinghouse I use the old robber to do the bottom part. There was a robber there before I thing?? Better than the $100+ factory replacement one.

Fits the way it should.