Wolf bite nitro is a premium glass bed adhesion solution specifically engineered to bond nylon and nylon-based plastic printed parts directly to glass 3d printing build plates without lifting (also known in the industry as "warpage"). Wolf bite nitro also enables the smooth release of parts after printing. Wolf bite nitro was exclusively developed at Airwolf 3D in collaboration with noted polymer chemist professor miodrag "mickey" micic, Ph.D., A department chairman at Cerritos college in Norwalk, ca. Wolf bite nitro is applied with a polyurethane foam brush directly onto glass, eliminating the need for tape. One light application of wolf bite nitro can be used for several prints. After applying wolf bite nitro, printing can commence immediately, with either a heated or room-temperature bed. Airwolf 3D formulated the proprietary solution to promote excellent adhesion and to make printed part removal easy.
R**.
It works exactly as advertised. It worked for me the first time.
I bought this product because I hadn't successfully made a decent print trying to follow the various "glue" methods. Nylon is subject to poor bed adhesion and warping.I bought this along with a Borosilicate glass bed liner. The combination worked well my first print.I made one change from the recommended process: I secured the glass liner in place onto the cold bed with binder clips and then brushed the Wolfbite on the glass. I then heated the assembly together rather than following the exact manufacturer-recommended sequence of pre-heating the bed and then trying to secure the coated glass to an already hot bed. Worked for me, thus the glowing recommendation!By the way, it easily washes off with water between prints.
W**N
It works
My recommendation before applying this to your glass bed is to use to spray IPA on it and scrape whatever residue may be initially on it, then wipe it down thoroughly. Apply this stuff on it initially by painting it on from the back of the plate towards you, then without adding anymore nitro to the bed just brush horizontally to verify that the top surface is coated, then set your bed temp to 80 Celsius to dry the adhesive. This has been what works for my prints, the bottom layer stays on perfectly and takes a lot to remove the prints but it’s perfect.
S**L
Airwolf is the best!
Love Airwolf and their customer service. Super helpful personnel in determining which wolfbite/filament combo is best for our needs.
J**N
Worst
Absolutely could not get it to work!!!
Trustpilot
2 weeks ago
1 day ago
