KF5007 4 Inch 100mm Vise Mount Metal Brake Bender Attachment Bending Max Capacity 14 Gauge 2mm Mild Steel 1/8" Aluminum

This bender works well within its stated capacity. Just know that the blade has an included angle of 30 degrees, not 90 degrees, so you can easily bend to far if you want 90 degrees. Check your progress!

I’m using these products to bend 1/8” diameter steel rods. I think that this might be beyond what the priduct is designed for but it is doing the job- with a little bit of accommodation. I am happy with the product. I recommend using it with a rotatable vise that is mounted vertically on a vertical bar that can be clamped to your bench. Rhis has been working well for me.

It worked exactly as described. I only had 16 bends to make for a school project, and there was no deformation at all. I did however break my vise. I was using a cheater bar to bend the steel. Not in any way the fault of the product in this review. After replacing the vise with a larger 6” model, everything went smoothly.

These work way better than I expected. It easily bends 16 guage 304 stainless. When you are done you can just toss them in a drawer.

I bought this to put a 90 deg bend into 1.5" wide, 10 gauge stainless steel, even though it's only rated for considerably thinner 14 gauge. I used a length of pipe to get better leverage on my vise handle but then it did the job easily. There was no damage whatever to this device.

I had an idea that this tool exists, and I had a project with a lot of bends in .068 stainless. It was a lifesaver! Anybody who has tried to bend metal by clamping it in a vise and hammering it over — this is so much more precise and accurate!

So far this little brake has worked amazingly well. I got it for a project where I needed to bend some 14g stainless steel and it handled it just fine despite it being the max rated material it can handle. Finish could be a bit better, but it's cast so I'm not complaining. Definitely worth the money for small fabrication jobs. Works way better than those folding brakes you get at harbor freight. Keep in mind since it's vice mounted it takes quite a bit of strength to bend thicker material. There's not a lot of leverage on a vice arm. But it is doable.

Bends metal nicely

Does what it needs to do quite well however the magnet quality is terrible and it barely sticks to the vice jaws, falls off under its own weight.

今まで苦労して叩いて折り曲げていた鉄材がいとも簡単に曲げることができました。左右にぶれることもなくきれいに曲げることができたのは驚きです。何か月か前に購入を狙っていましたが欠品になりやすく今回手に入れられたのは幸いでした。

Good, doe's the job really well.

A simple and easy to use tool that produces professional looking and accurate bends. The results are so much better than can be obtained in a simply hammering the metal over in a vise.

面白いモノです。小物？薄モノの曲げを簡単にキレイにできました。買って良かったと思ってます。ですが、諸般の事情？で、少し小型？安価？？な万力を使った時に、開口長が不十分でセットに苦慮(挟むのにスペースがたらない)。そして、ネジ部の変形？が？ 使用する万力は大きく、最大締め付けが大きいなど頑丈なモノを使用した方が良いと思います。