🚀 Elevate Your Engine Game!
The Runleader Digital Engine Temperature Gauge is a multifunctional device that combines a temperature meter, tachometer, and hour meter to ensure your engine's health. With real-time monitoring, programmable alerts, and a robust waterproof design, this gauge is essential for anyone looking to maintain their lawn mower, generator, dirt bike, or marine compressor efficiently.
| Material Type | Acrylonitrile Butadiene Styrene (ABS) |
| Item Weight | 110 Grams |
| Item Dimensions | 2.64 x 1.38 x 0.69 inches |
R**.
On my harley
put it on rear cylinder to watch temp, works good
R**F
Working on Vespa 2 cycle PX150
Working without any config needed for my 1 cylinder 2 cycle Vespa, reading cylinder temp and RPM. I did adjust the temp warning to 200C and RPM warning to 7000 rpm. Manual says you can shut the sensor off by holding M and S together for 2 seconds, does not seem to work. Oh well, nice otherwise
R**K
Does not work properly
Runloader products are horrible. I have bought many different products from them hoping one of them would work. None of them have ever worked properly. Especially the temperature sensor. Once they come up to temp the sensor breaks. It’s not getting too hot because it was only 200° before it broke. They’re supposed to go 10 times that. Bad company, crappy products
B**.
Works every time
I have ordered a few of these now and I love them!
O**R
Cannot keep my eyes on the road
Bought this for my small motorcycle because I was concerned about it overheating after recent mods. The screen is constantly switching between temperature and rpm and run time. Although I have not had it out of the garage yet, it seems to have a built-in unsafe feature. Ever hear of distracted driving? I just read all 2 pages of the instructions again, and there is no way mentioned to keep LCD on 'temperature.' If I could do that, I could just glance down once and read the temp... got it, okay. But, I will have to keep glancing down many times to 'catch it' showing temp. Either that or stare at it steadily for a couple of minutes. Either way, my eyes will not be on the road where they are supposed to be! Yes, you can switch to temp with the buttons, but that is a PITA as others have stated, and also would cause me to not look at the road while I am fighting with them. According to one answer I got from another buyer, sounds like if you disconnect the rpm wire from the spark plug wire it will read temp only.... really?!? What an elegant solution that is! Might just chuck it and buy another brand. Not happy.
Trustpilot
1 week ago
3 weeks ago