Gardner Bender45-PMBUVB Push-Mount pushmount Base, 10 Pack, UV Black

This totally works for my project.

On the package: GB 45-PMBUVB push lock base cable tie mounting base, fits 1/4" holes. "UV" 5/16" X 9/16" mounting base to secure cable tie bundle to another surface. UPC032076915353. Made in USA 10 pieces in the package.Dimensions of each piece: overall height 11/16", 3/16" deep, 9/16" wide. When installed the tab will extend a little less that 3/8" of an inch under your panel(1/4" max panel thickness), height above mounted surface: 1/4". Depth/width at mounting point 3/16" x 3/8", exposed tab width approx 5/8" when flat. Open prong width (below panel) 3/16". Maximum cable tie width 3/16" x 1/16" thick.Very nice relatively low profile mounting base for a zip tie, not too squishy and apparently UV resistant if I'm interpreting the "UV" on the front of the package correctly.

FOSHIZZLE!!! These are freaking awesome. Great for nailing down wire looms in an engine bay. If it cant move, it wont rub thru. And believe me, I’ve see MANY a problem from wiring not properly secured.

These are good only smaller than I expected

These work great for securing wire bundles, tubing. Drill a 1/4" hole, push this holder in place and zip tie.

These popped right in the hole left when I removed strap to the car frame. You need your own wire tie to stick through it and worked like a charm since you can decide how long of a tie to use.

Wish they made these for bigger than a 1/4 Dia holes, but other than that works great

Perfect for mounting zip ties in engine compartment!

What I like best about these clips is you can use any length zip tie with them. There are reusable. Just remove the zip tie and leave the clip in the original spot and install a new zip tie.

Very brittle break easily

as expected

Good zip ties. Work well and as described.

Satisfait du service