Kingwin SSD Mounting Bracket for PCI, 2 x 2.5 Inch to PCI Internal Hard Drive Kit. Convert Any 2.5” Into One Slot, Screws Included, Quick & Easy Installation

The product is good, fit the tower well and practical. However the screw holes holding the drive in place are a bit weak and can break upon tightening. Still keeping drive in place, but not neat.

نوعيته معدنيه جيده و معه براغي كافيه. لكن في كمبيوتري احتجت الى 3 قطع موصله ببعض حتى تناسب القرص الصلب العادي و لحسن الحظ طلبت وحدتين لأنه في كل وحدة يوجد قطعتا توصيل

Mounting a WD Gold hard drive. I've tried a few 5.25-3.5 adapters but with all of them the mounting points were completely misaligned to the point you simply can't get a screw in there. This kingwin is too but it's at least workable.If your 3.5" drive has the mount points at the front and rear of the device's sides (as mine did) and does not have mounting points in the middle, you can only install 2 screws either at the front OR back points. With the metal mounts that i tried that means the pcb made contact with the metal but thankfully this thing is plastic. The same goes for the mounting mounts at the bottom of the drive (2 only).No 3.5" front panel covers were provided and the panel is left open and ugly as pictured. The long and short screws provided also can't be used on the mounting holes at the bottom as the screw heads are smaller than the mounting holes and fall right through.If i needed to buy an adapter again i'll be avoiding this one like the plague and get the vantec ones instead because they appear to at least come with the front cover.

Used to mount an extra hard drive. Fits well and works as intended

works fine with me

Muy buen material y media exactas, funcional y fácil de instalar.

Nice !! Has anti vibration pads too :-)

Worked perfect for a 3.5 bay I wanted to add to my system!

This Kingwin Tech internal 3 x 2.5" HDD to 5.25" metal adapter is a very nifty bracket. It worked perfectly for me. There are some things you should know; read on!I needed to install a couple of SSDs (every one of my 6 SATA connectors is used) and this was a beauty.1. The SSD that went on the bottom ONLY uses bottom screws for attaching.2. I skipped the middle, which provided some room to plug/remove the cables, and installed the other SSD on the top.3. Both middle and top slots use side screws for attachment, unless the bracket is flipped, which would make the top the bottom and vice-versa.4. One more thing that is WORTH mentioning is that this is NOT as tall as a regular 5.25" unit (CD/DVD). It is shorter. For my situation it was a blessing, since one of the SATA power cables makes a loop (plug is in the middle of cable) and needs space above and below.5. It has two (2) sets of bolting patterns (onto the computer case). Use the top ones and it will be flush with the bottom of the 5.25" space available. Use the bottom ones, and it will be flush with the top. COOL!6. These metal brackets are made of fairly thick gauge galvanized sheet-metal (probably 18ga), which provides plenty of metal for the screws to grab onto without ever stripping the female threads. This is GREAT!7. A little Warning: DO NOT slide your fingers alongside the edge of the metal, since these were not filed/sanded into a ultra-safe/smooth roundness; it MAY cut through the skin. The shearing press used was very good, and NORMAL handling is totally safe. Rounding the edges would have increased the cost of these units substantially.8. Great Value.