Viborg HiFi Power Plug, VF503R, Rhodium-Plated Copper Non-Magnetic, 15A/125V 10A/250V AC, Audio Mains Plug, Set Screws, Hi-End IEC C15 Power Connector for DIY Audiophile Power Cable

I have resorted to making my own power cable upgrades spec’d to the needed length - Using 10 or 12ga with quality copper and sheathing and Viborg ends, I am very pleased with the results matched with “Hospital-grade” wall plugs and good quality surge suppressors. Sorry, I can’t justify $1k+ 1 meter cables - Still too much smoke and mirrors there.

AS advertised BUT Plan and plan some more. There is no room for missed calculations or extra wire. The enclosure is precise and exact fitting is demanded.

Decided to give them a try (Gold&Silver plated versions) after been using Wattgates/Marinco and Furutech. Quality is decent but no where near the Furutech as can be expected considering the cost. All these other plugs are much easier to terminate. Like the video shows buy an electric/battery powered screw driver to remove the screws. Many. many turns. The video also shows the power cord wires are soldered at the ends to prevent stray strands from not getting completely clamped down. (Try to the clamp down on bare strands and not the soldered portion of the wire if you are very precise.) This is very important. One my two plugs neither had the correct color of the neutral and ground screw. Hot is Gold, Silver is neutral and ground is green. (Mine had a greenish color on the neutral and black on the ground!?) If your not careful...the back of the plug did however have the correct markings where the wires should go but the screw colors were not correct IMO.) As another reviewer stated, plugs are very tight going into the male chassis IEC. If you're not careful, you will not insert them fully. (Never had this issue with any other IEC connector I've ever used be it any pre-made cord or one that I made myself.) OVERALL, a decent plug which most importantly, sounds very good. I think they are better than the entry level Wattgates overall sound quality wise. Wonder how the higher end Viborg's are? But now they are in other price category competing w/other high end manufacturers. Hope this helps w/your decision...Go ahead and them a try, but have patience and be careful w/assembly.

I ended up returning the ones I bought as I found them to be 'creaky' when manipulated as the plastic they are made from is hard with no flexibility.

The build quality of this connector is superb! However, it is a heavy connector. If you plan to use this with a heavy cable, it will need to be supported to maintain a tight connection.

Would not hesitate to purchase again!

I picked these for price, wasn't trying to improve anything besides make custom length power cables.

Nice large holes for big wires, looks a little strange with the facets (angles) but I don't need to look at them (hidden under cabinet) Not especially "high end", but they get the job done. Fits well in the socket.

Very transparent but needs a lot of burn-in to get to it's full potential. But even half-way through, it's impressive.

bon connecteur mais un peut trop difficile a inserer dans la prise iec male.

Good product, but apparently someone else returned and the seller did not check if all the parts are in order. I am missing parts the clamp that secure the cable.